flexure

The development of flexure hinges with large deflection, low stress, small parasitic center shift has always been a difficult problem.

The concept design theory of this flexure hinge was analyzed, and a mathematic model was established to analyze its performance.

Various degrees of each damage were simulated by the reduce of flexure resistance in several parts of the modal.

The design concept of flexure supporting structure is proposed for mirrors with higher profile accuracy requirements.

The flexure hinge is widely used in the micromanipulator due to its special natures.

When soft, the substance allows for greater flexure, but when rigid can reduce the strength of a bullet impact by more than half.

The beam and the pans are suspended from Cu-Be flexure-strips, which are designed to allow mass comparison between objects up to 2 kg.

The force curves may account clearly for the differences of aerodynamics between a flapping wing with and without a wing flexure.

Colonic disease distal to the splenic flexure may be treated with topical therapy, but other regions generally necessitate oral therapy.

The piezo flexure also operates over a much wider frequency bandwidth than conventional systems incorporating a tip mass.

It takes away any material you don't need and it actually garners flexure too , so -- I was going to break into a dance then .

In this paper, an integral formula for elliptical flexure hinge is deduced by introducing centrifugal angle as the integral variable.

The computation and experiment results indicate that the wing flexure can increase the average lift of the flapping wing.

Combining with theoretical analysis and laboratory tests, flexure characters of epoxy asphalt surfacing on steel decks are investigated.

Barium enema study revealed extravasation of barium into the liver parenchyma from the hepatic flexure of the colon.

The paper studies the sinusoidal control of micro displacement worktable, which based piezoelectric actuator and flexure hinge.

A novel flexure hinge, Right-Circular Corner-Filleted (RCCF) flexure hinge is presented for beam line of synchrotron radiation.

For the system of macro micro-feed table, a micro-feed table in macro-micro dual system was designed by using of flexure hinge.

Half elliptical flexure hinges are adopted in mechanisms where the compact structures are required.

The results show that the performance of the hybrid flexure hinge is much higher than that of right angle flexure hinge.

Reinforced concrete structures under severe dynamic loads may induce flexure, flexure-shear and direct shear failure modes.

A new concept of compliance accuracy ratio of flexure spherical hinge was proposed, which was used as the performance index of hinges.

PLASTICS. CARBON REINFORCED COMPOSITES. DETERMINATION OF INTERLAMINAR SHEAR STRENGTH. FLEXURE METHOD WITH SHORT SPAN LENGHT.

Cranial flexure is the middle of the three anterior flexures of a vertebrate embryo .

The tensile properties of microconcrete are investigated using flexure and split testing methods.

They were formed through regional isostatic adjustment and Theological flexure under the load of fold-thrust belts.

Ophthalmic optics - Contact lenses - Determination of rigid lens flexure and breakage.

which provides the reliable method for other ached structure flexure for other flexure destroyed position.

The influence of flexure and belt inertia was neglected during the course of model development.

Shear stresses and shear strains in prismatic members may be caused by either torsional moments, or by shear forces associated with flexure.

Asphalt mixture laboratory four-point flexure beam fatigue test was processed by controlled stress mode.

This feature is useful in solving center flexure as well as mitigating camber of product.

There may be additional zones of flexure within the device.

VPR pneumatic valve positioner (the VPR Locator) is Yamatake -Honeywell VFR Cam flexure control valve of the special annex.

for copper and other harmful oxidation of metal ions have a strong inhibition, but less flexure resistance.

Then the design of flexure hinge, finite element and fatigue life analysis are described in detail.

AIRCRAFT. HYDRAULIC TUBING JOINTS AND FITTINGS. ROTARY FLEXURE TEST.

The measuring results of flexure in an engineering case are presented in the end.

This paper raises a scheme of a micro-manipulation end-effecter based on flexure hinge for the MEMS research and test.

Susu honey , if I am not obedient, you can flexure I ?

Want to establish refreshing signpost sign in the highway crossing street corner, steep gradient and flexure pass.

The flapping wing with a wing flexure consumes less energy than that without a wing flexure in a flapping cycle.

The influence of flexure hinges on the static and dynamic performance of micro-feed stage based on finite element methods is analyzed.

Flexure yield of composite beam was checked by moment-curvature curve.

Aerospace series - Cables, electrical, aircarft use - Test methods - Part 512 : flexure endurance.

A rotational stiffness model for single-notch circular flexure hinge is established based on finite element method.

and, from the flexure of the splinters , we may know which way it fell.

Because of the special performance, flexure hinge has been applied widely in the fields of precision machine and micro- nano - technology.

A still more difficult distinction is that between a sharp flexure and a fault.

Thereinto, the method of passive compensation can not be used for flexure type GMA.

The piezo flexure may be supported at an intermediate point or at one end thereof.

a flexure of the colon.

Flexure in Moist and Thermal State of Two-way Orthogonal Isomerism Rectangle Slab in Every Direction

Calculation method of bearing capacity in flexure resistance of bridge reinforced by adhesive carbon fibre textile and its application

Position Determination of Maximum Lateral Flexure for a Tapered Beam by Local Finite Difference Method

Application of the Laminated Board Flexure Theory in Reinforcement Concrete Board Strengthening Projects

the honeycomb board flexure, which led to a crane in the upper-class fault;

Recommendations for the presentation of plastics design data - Mechanical properties - Creep in flexure at low strains

Optimizing Flexure Hinges of a Planar Full Compliant Parallel Mechanism

Study of flexure resistance of glass fiber cords for reinforcing rubber products

Investigation of bearing capacity to flexure of reinforced concrete slab-column connections on columns with cross-shaped cross-section

Stiffness characteristics of two types of micro-motion flexure linear guides

Aerospace series - Cables, electrical, aircraft use - Test methods - Flexure endurance

Flexure hinge and its application in precision parallel manipulators

Torsion Stiffness of Reinforced Concrete Compression-flexure-shear-torsion Components

The Equivalent Beam Methodology and its Application in Flexure Hinge Mechanism

Experimental study on flexure resistance and fatigue characteristic of coarse synthetic fiber concrete

Electrode Location Efficiency and Equivalent Circuit for Flexure Vibration of Piezoelectric Beam

Finite element analysis of diaphragm flexure in atmospheric sounding interferometer

The Diagnosis and Treatment of Splenic Flexure Syndrome Which Caused Severe Incomplete Colon Construction

Stress Capability and Accounting Measures of High Strength Flexure Reinforced Concrete Element

Standard Test Method for Compressive Strength of Hydraulic-Cement Mortars (Using Portions of Prisms Broken in Flexure)

Calculation of flexure strength for steel reinforced lightweight concrete elements

Method for the determination of the flexure strength of graphite electrodes

Comparison and research of the behavior of cold-formed thin-walled channel purl under flexure-torsion

Practical Cross Section Flexure Load Capacity Calculation Method for CFS Strengthened RC Members

Static Balancing Equation of Micro- Manipulators with Monolithic Flexure Joints

Experimental research on the flexure performance of steel-reinforced concrete members in the flexure

Non-linear Analysis of Flexure Section of Tension - Compression Prestressed Concrete

Analysis on the Output Displacement and Coupling Error of Single Parallel Four -bar Flexure Hinge Mechanism

Testing of Plastic Films and Plastics-coated Fabrics; Determination of Stiffness under Flexure

The force-restoring model of corroded reinforced concrete members with flexure and compression

Discussion About Flexure Strength Calculation of Steel Section Concrete Pillar

Buckling Analysis of the Parallel Four-bar Mechanism Right-angle-notch Flexure Hinges

Resistance flexure performance research on concrete reinforced by carbon fiber grid

Rectangle Sectional Of Controlling Calculation Of Strength And Rigidity Of Members In Flexure

Plastics; Determination of modulus of elasticity by alternating flexure

The analysis of flexure indices during designing and constructing asphalt pavement

Research on the ship flexure on-line modeling

Amplitude Distribution of Flexure Vibration on Piezoelectric Beam

Solution of elastic flexure equation by difference method for orthotropic sandwich slab

Analysis on the fatigue and flexure-tension resistant performance of semi-rigid roadbase material reinforced by soil engineering grid

Design for a Double Parallel Four-bai Flexure Hinge Mechanism in Micropositioner

Characteristic analysis of elliptical flexure hinges

A Study on Flexure Eight- bars Symmetric Linkage Nanopositioning Mechanism and Its System

Calculation and analysis of rotational stiffness for three types of flexure hinges

Design for high-precision quartz vibrating-beam accelerometer flexure hinge

Comparison of crack width equations for reinforced concrete members with flexure

Rotation Precision Calculation and Analysis of Typical Flexure Hinges

The embryonic body flexed and turned around, and then cephalic flexure, cervical flexure and dorsal flexure emerged at the 7th stage;

Method of test for compressive strength of polyester resin concrete using portions of beams broken in flexure

Standard Test Methods of Flexure Testing of Slate (Modulus of Rupture, Modulus of Elasticity)

The resonant character of crab-leg flexure of electro-static driven comb micro-resonant structure

Behavior of concrete-filled steel tubes subjected to flexure after exposure to standard fire

Standard Test Methods for Strength of Glass by Flexure (Determination of Modulus of Rupture)

Flexure of cut T-style steel under axial pressure and its application

Realization of Four-DOF Precision Adjustment Mechanism of Mirror With Flexure Hinge

verification regulation of flexure testing machine

Aerospace series - Cables, electrical, aircraft use; Test methods - Part 512: Flexure endurance

Method for rotary flexure testing of hydraulic tubing joints and fittings for aerospace use

Standard Method of Test for Compressive Strength of Concrete Using Portions of Beams Broken in Flexure

The Rotational Compliance Formula of the Flexure Hinges is Ratiocinated Based on the Flexibility Curve Equation

Aerospace series - Fibres and cables, optical, aircraft use - Test methods - Part 512: Flexure endurance

Discuss the flexure index during take design and construction in asphalt pavement

Devices Feature Seven Package Sizes With Available Polymer Terminations to Prevent Board Flexure Cracks

Standard Test Method for Effect of Surface Grinding on Flexure Strength of Advanced Ceramics

Test method for flexure testing of slate (modulus of rupture, modulus of elasticity)

The Measurement of Nano-flexure of Silicon Wafers by Five-frame Phase-shifting Algorithm

sliding section; flexuring section; moment of flexure;

When the amount of doped-Al2O3 was 9mol%, the relative density, hardness and flexure strength of composite ceramics reached the maximum;

Finite element analysis for parallel micro-moving flexure joint robot

Application of Flexure-hinge Micro-motion Amplifier in Piston Turning

Design Calculation and Analysis of Half Elliptical Flexure Hinge

standard test method for flexure creep of sandwich constructions

Design and Analysis of a Micro-manipulation End-effector Based on Flexure Hinge

Method of test for compressive strength of concrete using portions of beams broken in flexure

testing of artificial leather ; repeated flexure test

Nonlinearity Analysis of Three Typical Flexure Hinges

Study on Transfer Alignment with the Flexure of the Carrier

study on the static stiffness of the parallel flexure joint robot

Surgical treatment of duodenal invasion by cancer of hepatic flexure of colon

The analysis of flexure destroy limit of slowing bonding initial stress beam

Influence of Coarse Aggregate Grading on Flexure Strength

standard test methods for testing structural panels in flexure

Experimental Analysis and Simulation of Microgripper with Flexure Hinge

The Application of Flexure in the Double-crystal Monochromator

Mechanical Performance of Right-Angle Flexure Hinge

Design of flexure hinge in beam line of synchrotron radiation

Diagnosis and Treatment for Elderly Patients with Syndrome of Splenic Flexure of Colon (Report of 22 Cases )

Structural Dynamic Modification of Flexure Hinge Structure Based on Artificial Neural Network

Optimal Design of the Flexure Hinge Parameter Based on Space Micro-displacement Worktable

Flexure hinge in beam line of synchrotron radiation

Design of Large Displacement and High Precision Linear Stage Based on Laminated Flexure Hinge and Ultrasonic Motor

Design and Finite Element Analysis of Spiral Flexure Spring

Study on Transfer Alignment with the Wing Flexure of Aircraft

Error Sources Analysis of Flexure Hinge Mechanism

Exact Design Equation of Half Right Circular Flexure Hinge

An experimental study on flexure and shear behavior of R. C hollow shear wall

Design Calculation and Analysis of Flexure Hinge

Testing and analysis of asphalt pavement flexure

Malignant neoplasm of hepatic flexure

Discuss Dysfunction of Qi from Flexure Syndrome

Design and Analysis of Flexure Hinges Micro-Grabber

Analysis of Checkout Error for Distortion and Flexure Caused by Tapers of Crank Bore and Piston Pin Eye

Deduction of Design Equation of Flexure Hinge

Conparsion on Two Methods of Transfer Alignment with Carrier Flexure

Research on half hyperbolic flexure hinge based on closed-form compliance equations

Optimal design of flexure-based compliant mechanisms based on probability

Design of Elliptical Flexure Hinges

bending moment (moment of flexure)

The pond or the river course border very little builds the neat stoneshore, always the height flexure lets things take their naturalcourse

Test method of ferrocement panels in flexure

Effects of Sigmoid Flexure Lavage on Ileus

On Flexure Change and Test of Asphalt Pavement

test method for flexure of glass material

Study on the Accuracy of Flexure Hinges

Tests on Pre-flexure Composite Beam

a flexure attached to the load beam so as to support the slider;

Study on a Hybrid Flexure Hinge

Analysis and improvements on the structure of flexure hinge in micropositioner by using finite element

Optimal Design of Flexure Hinge Micro-gripper Actuated by PZT Based on FEM

A Design of Three Dimensional Analog Probe Based on Flexure Hinges

Study on design method of one-axis flexure hinge

Parametric Solid Modeling of Flexure Hinge Mechanism Based on APDL

The Automation tester of flexure Based on PLC