cold-worked

Hot rolled stainless steel bars that are annealed and cold worked to produce a higher surface quality and higher strength.

The relief of some of the internal strain energy of a previously cold-worked metal, usually by heat treatment.

The primary purpose of annealing is to soften hard steel so that it may be machined or cold worked.

Cold worked reinforcement loses more strength than hot rolled bars.

When cold-worked the hardness is greatly increased.

For welding in cold-worked areas, the minimum bending radii (e. g. according to DIN 18800) shall be observed.

Studies have shown that (in the same units) the hardness of a cold-worked metal is about three times its yield stress, Y;

Deformation-Induced Martensite of Cold-Worked Stainless Steel and Its Corrosion Behaviors

Standard Specification for Seamless, Welded, and Heavily Cold Worked Austenitic Stainless Steel Pipes

Copper-nickel-silicon alloy rods, sections and parts (solution treated, cold worked and precipitation treated)

Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar

The Relationship Between Rolling Rate and Plasticity of the Cold Worked Bars

Tubes of wrought nickel and nickel alloys, cold worked; dimensions, tolerances

Mechanical Analysis of Cold-worked Hole by Photo-plastics

Approach to tendency of cold-worked carbon steels to ageing

The Process of Cold Worked Hole With Split-Sleeve