voltage across

The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.

The spark consists of an electric are produced by applying a high voltage across the electrodes of a spark plug.

The voltage across the resistor is a few tenths of a volt.

While it is charging, a voltage comparator constantly compares the voltage across the capacitor to a reference voltage.

Capacitor C then is charged through RA until the voltage across the capacitor reaches the threshold voltage of the threshold (THRES) input.

The unique output full -bridge incorporates source-side linear operation to allow a constant voltage across the motor coil .

As shown in Figure 2-2, the input bias current (IBIAS) develops an error voltage across the source resistance (RS).

Finally, the capacitor is open- circuited and, after a third time interval, the residual voltage across the capacitor is measured.

The dissertation also presents the main steady characteristics, the ripple of current through inductor and voltage across capacitor.

If a constant current is applied to the capacitor, the voltage across the capacitor will rise at a constant rate.

To test passive components, the tester places a test voltage across the component under test and measures the current.

The voltage across this capacitor is a few hundredths of a volt.

It shows that the error rate of the OLED current can be further decreased to 5 % when the voltage across OLED are raised.

Therefore, the subsequent programmed output voltage will be the actual voltage across the load.

Select Branch voltage to measure the voltage across the Series RLC Load block terminals.

will respond by producing a transient voltage across the fuse cutout.

The electrical switches conduct heavy current and have nonzero voltage across the switch in the on-state.

The voltage across RL1 is the picoammeter voltage burden, normally less than one millivolt, so the resulting current will be quite small.

It is necessary to find out the current through and the voltage across the resistor.

The voltage across an ideal current source is completely determined by the circuit it is connected to.

The voltmeter will read the difference between the two electrometers' buffer outputs, which is equal to the voltage across R2.

A current detecting circuit 6 is connected to both ends of the resistor 2 and detects a current from a voltage across the resistor 2.

Since all three elements are in parallel, they must all have the same voltage across them.

For example, very high resistance values can be determined by applying a voltage across a device and measuring the resulting current.

Development of a High-Voltage Probe for Measuring Impulse Voltage across Thyristor Components in HVDC Converter Valve

Dynamic Behavior of Voltage Across Small Capacitance Josephson Junction

Calculation of voltage across faulted open port in power system fault analysis

An incorrect trip of circuit breaker caused by measuring the voltage across it's protection tie strap

It is necessary to find out the voltage across and the current through this resistor

Impress a voltage across a circuit