网站首页  词典首页

请输入您要查询的英文单词:

 

单词 slot 1
释义

slot 1

例句

释义:
1.
A year later I acquired a programmable calculator with a tiny engine that pulled magnetic memory cards through its slot.
1年后,我买了一个可以编程的计算器,可以插进存储卡。
bbs.translators.com.cn
2.
So now $10 has all ones in the preferred slot if it is in range, and all zeroes if it is out of range.
因此现在如果这个值在这个范围内,则$10在首选slot中的值就全部为1;反之则全部是0。
www.ibm.com
3.
Or, you can select the related PCI slot to let Daughter Card Slot 1 show up to system first with lowest device ID (see Figure 3).
或者,您可以选择相关的PCI插槽以让DaughterCardSlot1首先以最低的设备ID显示给系统(参见图3)。
www.ibm.com
4.
Are to be cut into a clamping foot with a maximum height of 2 " with a 1" slot for clamping.
应该切割成带有2“高及1”固定槽的固定垫脚
blog.sina.com.cn
5.
Provide an airfoil at the sill of the sash opening. It shall be mounted to provide a 1 inch slot above the hood interior counter top.
开口拉门处有一个翼面,安装时应在内部台面上留有1英寸的狭缝。
bbs.translators.com.cn
6.
MAKE SURE THIS WEAPON IS IN SLOT #1 (the upper left corner) of your main bag, the backpack.
确保这武器是在主背包的第一格(左上角)。
apps.hi.baidu.com
7.
A bolt pair (4) and a hanger (1) are fixedly connected above the two axial sides of a bracket (2) mounting hole or a slot respectively.
所述托架(2)安装孔或槽径向两侧的上方分别有螺栓副(4)与吊架(1)固定连接。
ip.com
8.
IsEquippedAction(slot) - Return 1 if an action is equipped (i. e. connected to an item that must be equipped), nil otherwise.
如果指定动作条上是一个装备(能穿在身上的),返回1,否则返回空。
iask.sina.com.cn
9.
For the texture slot I used an HDRI and sometimes only a bitmap.
对于纹理插槽我用了一个HDRI有时甚至只有1位图。
blog.sina.com.cn
10.
Actually, it's also smaller than $1, 300 units, although those come with 20GB HDs and not just a slot for Mini SD 4GB cards.
实际上,它也比1300美金的那些要小,尽管那些是连同20GB的硬盘,而不是一个迷你4GBSD卡插槽。
www.elanso.com
1.
If you put a 10 Casino chip in a slot machine with a 1 coin setting, your coin credits will be 10.
如果您用1硬币设置,放入10筹码到老虎机,您存入的硬币为10。
casinochance.com
2.
Figure 1 shows the installation entity of new stone of the short-slot stone curtain wall.
附图1为短槽式石材幕墙新石材安装实体示意图。
ip.com
3.
IsAttackAction(slot) - Return 1 if an action is an 'attack' action (flashes during combat), nil otherwise.
如果指定的动作条是“攻击”(在战斗中闪烁),返回1,否则返回空。
iask.sina.com.cn
4.
Don't have been turn on a big faucet while washing a vegetable, but clean to flush 1 time with water again in the clear water slot first.
洗蔬菜时不要一直开大水龙头,而是先在清水槽中洗干净再用水冲洗一遍。
zhidao.baidu.com
5.
Jaws: Hardened alloy steel with lubrication, keyway slot for tooling location, 32 degree jaw motion Each jaw travels 1 degree beyond center.
大白鲨:硬化合金钢与润滑,键槽插槽工具的位置,32度下颌运动每超出1颚旅游中心的程度。
www.testmart.cn
6.
This implies that the 743 may be the "slot 1 controller" from any slot in the VME backplane.
这意味着743可以从VME背板中的任何插槽上成为“插槽1控制器”。
e-support.hp.com.cn
7.
End mills and slot drills - Part 1: milling cutters with cylindrical shanks.
端铣刀和槽铣刀.第1部分:直柄铣刀
www.mapeng.net
8.
'Date Night' (Fox), took in $27. 1 million to take the top slot, according to early estimates from Hollywood. com.
票房跟踪网站Hollywood.com的初步票房数据显示,福克斯(fox)公司出品的《约会之夜》票房为2710万美元,居榜首。
chinese.wsj.com
9.
IsAutoRepeatAction(slot) - Return 1 if an action is auto-repeating, nil otherwise.
如果指定动作可以自动重复,返回1,否则返回空。
iask.sina.com.cn
10.
IsUsableAction(slot) - Return 1 if an action can be used at present, nil otherwise.
如果该动作可以马上被使用,返回1,否则返回空。
iask.sina.com.cn
1.
SCO packets are always 1 slot in length.
SCO数据包时隙长度始终是1时隙。
www.bing.com
2.
IsCurrentAction(slot) - Return 1 if an action is the one currently underway, nil otherwise.
如果指定动作正在进行中,返回1,否则返回空。
iask.sina.com.cn
3.
every rogue now has their own deadly poison debuff slot on monsters , instead of 1 for all.
对于同一个怪物,每个盗贼都可以叠加自己的致命毒药,而不像之前所有人叠加一个。
www.ichacha.net
4.
The high key value on page (1: 77) (level 0) is not less than the low key value in the parent (0: 1), slot 0 of the next page (1: 82).
高键值(1:77)(级别0)页上是父中低键值不小于(1),0插槽0是下一页(1:82):。
support.microsoft.com
5.
Rule 3. 3 states, "The Arbiter must always be located in slot 1. "
第3.3条规则指出:“仲裁器必须使用在插槽1中。”
e-support.hp.com.cn
6.
folding Blade Knife thick 1. 0 mm slot width 2 mm, blade tip and sample contact semicircle, its radius of 0. 5 mm.
折叠刀片厚1.0毫米,刀缝宽度2毫米,刀片端部与试样接触呈半圆形,其半径为0.5毫米。
www.bing.com
7.
Tip1: Remember that with Mental Ray the fake reflection is NOT visible in the material slot as preview.
提示1:记住使用mental的话,模拟反射在材质球预览框里是不可见的。
www.cgbegin.com
8.
Metal-cutting Tools; Hobs for Spur Gears, with Clutch Drive Slot or Keyway, Modules 1 to 20
金属切削刀具。正齿轮用带横向键槽或纵向键槽的滚铣刀。模数1至20
www.std168.com
随便看

 

英汉双解词典包含2704715条英汉词条,基本涵盖了全部常用单词的翻译及用法,是英语学习的有利工具。

 

Copyright © 2004-2022 Newdu.com All Rights Reserved
更新时间:2025/2/7 12:00:36