strain distribution

A hybrid grid method was used to determine the principal plastic strain distribution in a deformed area of a sheet metal piece.

commonly , ultrasound elastography can only obtain the axial strain distribution of tissues with an external compression.

However, global structural stress and strain distribution can be calculated quickly, correctly and intuitively by finite element software.

The results show that the severe asymmetry of strain distribution as a consequence of the offset causes the specimen to ro .

It determined that the model of strain distribution on the flange of frame can be expressed as a plane.

and calculating the strain distribution, length and mass of the pile or brad with the physical quantity in the data treating circuit.

and the variation of deformation velocity causes the strain distribution to vary along the cross-section profile.

It shows common features of regional vertical deformation anomaly area and high strain distribution area of horizontal deformation.

Through analysing and discussing in calculating plastic strain distribution map and safety factor received.

Secondly, the model of deck pavement is analyzed by finite element software ANSYS to get its stress and strain distribution.

Comparison of four different combinations of the same time, the stress and strain distribution, the size of the plastic zone.

It reveals the metal flowing rule in stagger backward spinning process and the rule of stress-strain distribution in the workpiece.

The impact of film size on the strain distribution is investigated, and the intuitive and reliable results are attained.

The method was used to study an automobile stamped panel part with quality defects as an example with the strain distribution compared. . .

Study of deflection and strain distribution sensing of a simply supported rectangular plate based on fiber Bragg grating sensors;

Analysis on the strain distribution of carbon fiber in coherent length of member in bending

Experimental Study on Strain Distribution in Fiber Coil Used in Fiber Optic Gyroscope

The Measurement of Biological Soft Tissue Internal Strain Distribution Under Compression

Measurement of strain distribution on base plate of maxillary complete denture with static resistance gage

Determination of Strain Distribution and Forming Defects for Automobile Panel Stamped Parts

Influence of welding with trailing peening on strain distribution of welded joint of high strength aluminum alloy;

A research on strain distribution evolution process of short-limbed wall structure under horizontal cyclic loading

Influence of Elastic Modulus of Adhesive on the Stress and Strain Distribution in Aluminium Single Lap Joint

Finite Element Simulation of Effect of Conical Feeding Angle on Swaging Strain Distribution of Pure Magnesium

Computation and Simulation of Strain Distribution for Hot Rolled High Strength Plate

Effect Research of Forming Process on the Shock Absorber Substrate's Strain Distribution

Fast and Accurate Estimation of Blank Shape and Strain Distribution for Sheet Metal Forming

A Finite-element Method for Calculating Strain Distribution in Quantum Dots

The calculation of strain distribution in quantum dots with Green method

Finite element analysis of rail strain distribution

Stress and strain distribution in front of notch with different sizes on specimens loaded with different rates

Finite element analysis of stress and strain distribution in front of notches under mixed-mode loading

Effect of blunted pre-cracking on stress and strain distribution

Stress and strain distribution and strength of weldbonded joints with two spots