noise(1)

Then I heard a noise, and I knew it was the sound of human terror.

Therefore, before laser scanning's the data points to obtain renewal the data must be carried out to remove noise. (1) Data pre-processing.

Idea 1: Mark walks through the machine and is soon covered in soapsuds . But he gets scared by all the noise and hoses and runs out.

Do not trade any market whose average noise level is more than 1% of your equity.

ACOUSTICS. LABORATORY TESTS ON NOISE FORM TAPWARE AND HYDRAULIC EQUIPMENT USED IN WATER INSTALLATIONS. PART 1 : METHOD OF MEASUREMENT.

Household and similar electrical appliances - Test code for the determination of airborne acoustical noise - Part 1 : general requirements.

Hydraulic fluid power - Determination of the fluid-borne noise characteristics of components and systems - Part 1 : introduction.

acoustics . recommended practice for the design of low - noise workplaces containing machinery . part 1 : noise control strategies.

In August the World Health Organisation released the preliminary results of its research into the links between noise and stress(1).

In the Specular Weight #1 channel a noise map is then used to soften and further control the overall specular effect.

Example #1: Tell someone to think of the noise of thunder and watch their eyes.

Even if the signal is affected by noise, with suitable sampling frequency, the maximum error is only 1. 33%.

Normal mode noise is detected as a peak noise or deviation in a DC signal.

The main power of the machine adopts 1. 5KW 220V Panasonic frequency converter and inverter motor with stable performance and low noise.

Acoustics - Measurement of the influence of road surfaces on traffic noise - Part 1 : statistical Pass-By method.

As a result, entered into the decoder as a signal and noise ratio (here now for Watermarking W) much less than 1.

With noise level held to meet national standards, the noise 1m away from fan cover should be confined below 85 dB.

hydraulic fluid power . test code for determination of airborne noise levels . part 1 : pumps.

Click on "Filter, " "Add Noise" and set noise to 1%, "Gaussian" and "Monochromatic. "

The main researches are summarized as follows: (1) The optimal design for the most effective structure of vibration and noise reduction.

A constant 1. 2 MHz switching frequency, with current-mode control scheme, provides stable low-noise operation at high load conditions.

And at the last, a model of white noise are constructed via the stochastic process with 1-dimes. . .

frequency spectrum requires about 1 minute and permits digital filtering of noise.

Textile machinery - Noise test code - Part 1 : common requirements.

The KM-1 features a well balanced zinc alloy body with low handling noise and a durable mesh steel grille that is dent resistant.

About 15 per cent of the 1, 400 complaints that the city's pollution control team receives on average each year involve dog noise.

Corrigendum 1 - Industrial -process control valves - Part 8 -4: Noise considerations - Prediction of noise generated by hydrodynamic flow.

The dones following: 1. Make triple wavelet transform to the original images, and then decrease the noise.

Then using GM(1, 1) model, a predicting of Wuhan city road traffic noise condition prior to the year 2008 was made.

rated the highest form of noise pollution on a scale ranging from 1 to 7.

Measuring signals at or near Johnson noise limitations (as indicated in Figure 1-2).

Noise at 100 decibels can cause damage after 15 minutes, while noise at 94 decibels can cause damage after an hour.

There is little point smoothing 1 dimensional noise, since these are really the only effects.

All mechanical ventilation systems must meet the indoor ambient noise levels in Table 1. 1 of BB93.

In the post, add 1 or 2 spot of the Gaussian blur, and then add one noise.

Reduced noise floor above 1 GHz.

The justification of(13. 2-2)as a representation of spontaneous emission noise is provided by the discussion preceding (13. 1-7).

Controls the noise granularity (if the Noise value, above, is non-zero). The range is 0 to 1. The default is 0. 5.

Acoustics - Description, measurement and assessment of environmental noise - Part 1: Basic quantities and assessment procedures

Acoustics-Household and similar electrical appliances--Test code for determination of airborne acoustical noise Part 1: General requirements

Road traffic noise reducing devices - Non-acoustic performance - Part 1: Mechanical performance and stability requirements

The new Type 62-1 model had air conditioning, a larger fresh water tank, stabilizer fins, and much reduced engine noise.

Hydraulic fluid power - Determination of fluid-borne noise characteristics of components and systems - Part 1: Introduction

The experimental results indicate that: (1) Acoustical shielding reduces engine supersonic jet noise distinctly;

Acoustics; Description and measurement of environmental noise; Part 1 : Basic quantities and procedures

Noise is generally defined as "unwanted sound" . Major concerns are 1. hearing damage resulting from exposure to excessive noise;

Acoustics - Recommended practice for the design of low-noise machinery and equipment - Part 1: Planning

Acoustics -- Noise from shooting ranges -- Part 1: Determination of muzzle blast by measurement

Acoustics - Measurement of Noise and Vibration of Small Air-Moving Devices, Part 1: Airborne noise Emission

Optical fibre amplifiers - Basic specification - Part 3-1: Test methods for noise figure parameters; Optical spectrum analyzer

Acoustics - Measurement of noise on board vessels; Technical Corrigendum 1

Noise abatement in town planning - Part 1: Fundamentals and directions for planning

Installation of Anti-Noise Barrier in the 1st Phase of Qingdao Urban Expressway Project

Underground environment noise analysis and the method of reducing noise in Line 1 of Guangzhou metro

Acoustic characteristics analysis and application of GZC- 1 high resolution noise logging tool

Noise Removal Using Second-Order Partial Differential Equation and H-1 Norm

Task 1: Your neighbour wrote a letter to yu to complain abt the noise your made. Write a letter to he, you should include