A spline is similar to a line chart except that it draws a fitted curve through the data points.

Torque locking sliders have the ends of their splines back cut.

Torque multipliers used for aircraft engine applications have a through output spline, designed specifically for use with anchor pins on either side of the fastener for reaction purposes.

However, a considerable notch effect of holes and splines on the shaft is a disadvantage of this design.

The Wafer® Shaper Cutters are designed for high production applications in external or internal gears and splines of spur or low helix angle configurations.

Hubs feature 3T-exclusive freewheel spline accepting both Campagnolo and Shimano/SRAM cassettes with no adapter.

This, in effect, causes the clutch tooth of the gear to sort of fit in a pocket within the slider’s spline, or it forces the gear to ramp in toward the center of the slider, whether you’re on or off the gas.

The technology used by the program is called S-Spline, a patented mathematical algorithm capable of minimizing the effects of zooming.

Note: In case of spline of type A to E, the item "Preferred series" has no meaning and the design will be executed for the complete series of dimensions.

To best drive insight from your data, NetAdvantage for Silverlight offers over 50 different types of charts - including bar, line, bubble, scatter, spline, radial charts, and more.

The check is carried out for the diameter of a solid shaft Dre, not weakened by splines [8.17].

Conceptually, the knots determine the B spline basis functions. The values of the B spline basis functions at the parameter determine how the control points and weights are averaged together to produce a point.

When determining the length, keep in mind that the chosen length of the spline is at the same time the minimum permissible length of the hub.

The design eliminates all solutions where the length of the hub results in more than a doubling of the outer diameter of spline.

One set of plates is attached to the outer drum via a spline connection, and one set is attached to the inner shaft via a spline.

The G Type offers the same accuracy, flexibility and ease of use as our Standard and Spline Mandrels, while providing a larger face on the headstock and drainage channels for the elimination of any fluid build up between the jaws and the slots.

HSM optimization for NURBS, spline-curve and arc-optimized G-code output is built into ESPRIT's universal post processor.

You can quickly create a mask by using the alpha, luminance, or RGB values of an image, then fine-tune the edges using Bezier or B-spline controls.

In the list, choose a range of input data (spline dimensions) used by the automatic design for selection of a suitable solution.

The external spline major diameter and circular tooth thickness dimensions are reduced to assure a clearance fit with the mating spline.

In case the functional length of the spline results in a greater length, repeat the design for a spline with more grooves of a greater diameter.

When entering the values manually, first choose a suitable dimension of spline [8.13].

From a maintenance point of view the machine is no different from an ordinary drill rig, except that the splines in the hydraulic splitter will eventually wear out and will need to be replaced.

Barber Colman Company pioneered many new products in the field of hob design and manufacturing, introducing such inventions as the ground hobs, parallel key spline hobs, taper root hobs, elongated tooth spline shaft hobs, swing type and multiple thread ratchet hobs, gear chamfering hobs, equal chip, E-Z Cut®, K-Kut®, Tru-Form®, Q-D, Accu-Thread®, Rebladeable, and Precise type hobs.

Note: In case the result of the check is insufficient, a new design with a greater length, more grooves or a larger diameter of spline must be carried out.

Ten spline production lines,the production method of CNC rate reach to 70%.

Reliability against fatigue breaks affected adversely by notch effects of splines

Recommendations: In any case, the length of the hub should not be greater than double the outer diameter of the spline.