| 单词 | 螺丝母 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 释义 | 螺丝母 —nut (female component of nut and bolt)See also:螺丝 n—screws pl • screwdriver n • fastener n 螺—conch • snail • spiral shell 螺母 n—nuts pl • nut n • bolt n 丝 n—wire n • silk n
|
他们懂得用小螺丝、螺母、螺栓和 全金属部 件来搭建。 cpsc.gov | They can build with [...] sets using tiny screws, nuts and bolts, and all-metal parts. cpsc.gov |
方管、联轴卡子、联轴销子、螺丝和 螺母 都 是 用耐腐蚀钢 材制成的。 highvolt.de | Square tubes, coupling [...] brackets, coupling bolts, screws, nuts and lock tabs [...]are made of corrosion-resistant steel. highvolt.de |
卸下螺丝 （109，金属泵）或螺母 （112，塑料 泵）。 graco.com | Remove screws (109, metal pumps) or nuts (112, plastic pumps). graco.com |
b. 用 6 英寸活动扳手和 5/16 英寸螺母螺丝刀紧 固耦合器。 graco.com | b. Use a 6 in. adjustable [...] wrench and a 5/16 in. nut driver to securely [...]tighten coupler. graco.com |
始终备有一把 5/16 英寸螺母螺丝刀， 以迅速关闭联接块上的手动阀门。 graco.com | Always have a 5/16 in. nut driver available to [...] quickly close manual valves on coupling block. graco.com |
将喷枪维修配件包的维修块连接到喷枪，然后用 5/16 英寸螺母螺丝刀拧紧。 graco.com | Attach service block of gun service kit to gun, and [...] then tighten using 5/16 in. nut driver. graco.com |
用 5/16 英寸螺母螺丝刀卸 下联接块安装螺钉，分开 喷枪与联接块。 graco.com | Use 5/16 in. nut driver to remove coupling block mounting screw, and separate [...] gun from coupling block. graco.com |
若有必要，可用 5/16 英寸螺母螺丝刀握 牢阀杆。 graco.com | If necessary, use a 5/16 in. nut driver to hold valving rod. graco.com |
派尔杰科100kN E系列公制丝杆运动和螺母运动 螺 旋升降机，附带特制不锈钢螺杆，蜗轮推杆，盖管 和反齿隙构造。 powerjacks.com | Power Jacks 100kn E-Series metric translating and [...] rotating screw jacks, with special stainless steel screws, worm shafts [...]and cover pipes and fitted with an antibacklash feature. powerjacks.cn |
使用 5/16 英寸螺母螺丝刀打 开手动阀门；逆时针拧 动手动阀门大约三圈。 graco.com | Open manual [...] valves using 5/16 in. nut driver; turn manual [...]valves counterclockwise approximately three full turns. graco.com |
配件包 [...] 24E884 包括左右安装楔形装置 （55 和 56）、 六角螺母 (32) 和螺丝 (37)。 graco.com | Kit 24E884 includes right and left mounting wedges [...] (55 and 56), hex nuts (32) and screws (37). graco.com |
配件包 24E883 包括支架 (49)、两个六角螺母 (16) 和 两个螺丝 (23)。 graco.com | Kit 24E883 includes [...] bracket (49), two hex nuts (16), and two screws (23). graco.com |
用手指握牢滤网螺钉的大六角头或顶住坚固表面， 同时用 5/16 英寸螺母螺丝刀卸下滤网螺钉的安装螺 钉。 graco.com | Use a 5/16 in. nut driver to remove screen screw mounting screw while holding [...] large hex head of screen screw with finger or against solid surface. graco.com |
8) 用螺栓将分接选择器吊杆固定到油室底部：M12 内六 角螺丝 （8 号扳手） ，螺丝头，外侧的垫片和内侧的 螺母，最大扭距为 60 Nm （ 11）。 highvolt.de | 8) Fasten the tap selector suspension to the oil compartment bottom using the hexagon socket screws M12/w.s.8 (screw head and spring washer outside, nut inside, max. tightening torque 60 Nm, Figure 11). highvolt.de |
提升单向阀是依靠重力来动作的、故必需水平地安装、阀 帽 螺母 在上部。 swagelok.com | The lift check valve is gravity assisted and must be mounted [...] horizontally, with bonnet nut on top. swagelok.com |
为了避免损坏波纹管顶盖和 D 形密封 件，请勿旋转联接螺母。 graco.com | To avoid damage to the bellows top cap and the D-shaped seal, do [...] not turn the coupling nut. graco.com |
极性转换选择器端子 [...] K 是延伸出来的细级分接选择 器端子 （也有 M10 螺丝用的孔 37）。 highvolt.de | Reversing change-over selector terminal K is an extended tap selector terminal (also with [...] through-hole for M10 screws, Figure 37). highvolt.de |
要精确定位轴承，唯一需要的是移动驱 动 螺母 到 丝 杠 两 端。 schaeffler.cn | For the exact positioning of the bearing, the only procedure required [...] is to move the screw drive nut to both positions. schaeffler.us |
将一条最 小为 12 号的地线 (R) 的一端插入后面的接地 螺丝并牢固地拧紧螺丝。 graco.com | Insert one end of a 12 ga. minimum ground wire (R) behind the [...] grounding screw and tighten the screw securely. graco.com |
完成接线后，重新装好端子盒盖，并紧固 （3 个 M6 六角 螺丝， 3 个锁垫，扭矩 9.5 Nm）。 highvolt.de | Once the connections have been established, replace the cover and fasten [...] it (3 hex. head screws M6, 3 locking [...]washers, tightening torque 9.5 Nm). highvolt.de |
卸下转轴板 （A）上的两个螺丝、旋 转接头轴 （B）（如果 有必要），并从旋转接头轴上卸下耦合接头 [...] （C）。 graco.com | Remove two screws on pivot plate (A), [...] swivel shaft (B) if necessary, and remove coupling (C) from swivel shaft. graco.com |
配件包 24E883 包括支架 (28)、六角螺母 (32) 和螺丝 (17)。 graco.com | Kit 24E883 includes [...] bracket (28), hex nuts (32), and screws (17). graco.com |
插入联接块安装螺钉并使用 5/16 英寸螺母螺丝刀拧 紧枪块。 graco.com | Insert coupling block mounting screw and use 5/16 in. nut driver to tighten to gun block. graco.com |
检查与拧紧将歧管底座固定到安装支架 的 螺母 或螺 栓 (X)。 graco.com | Also check and tighten the nuts or bolts (X) holding the manifold feet to the mounting brackets. graco.com |
通过接线片和 M20 锁螺母 （30 号扳手，扭矩 80 Nm）进行分接选择器端子螺杆上的连接。 highvolt.de | The connection is made on the thread stud of the tap selector connection terminal using a cable shoe and M20/wrench 30 lock nut, tightening torque 80 Nm. highvolt.de |
重复以上调整步骤，直到获得所需的八度音，然后拧 紧琴弦锁上的压脚螺丝（图4 F）。 ibanez.co.jp | Repeat these adjustments until the required intonation is reached, and then tighten the [...] pressure pad screws (Fig. 4 F) in [...]the locking nuts. ibanez.co.jp |
该内螺母已进行了预先安装并被固 定在了正确的位置。 interroll.com | This inner nut has been preassembled [...] and secured in the correct position. interroll.com |
顺时针拧紧电池盖螺丝，锁紧 电池盖。 sonimtech.com | Turn the battery cover screws clockwise to lock [...] the battery cover. sonimtech.com |
安托瓦内特耕（弗朗西丝·康罗 伊），Desperea ux 的 母 亲 试 图向运行通过到停止的鼠标委员会发送Despereaux进地牢，但莱斯特（威廉H.梅西），安托瓦内特的丈夫，抓住她的胳膊，因为他关心更多关于鼠标会比他约Despereaux。 zh-cn.seekcartoon.com | Antoinette [...] Tilling (Frances Conroy), Despereaux’s mother tries to run through [...]to stop the Mouse Council from sending Despereaux [...]into the dungeon, but Lester (William H. Macy), Antoinette’s husband, grabs her by the arm, because he cares more about the Mouse Council than he does about Despereaux. seekcartoon.com |
英汉双解词典包含2273206条英汉词条，基本涵盖了全部常用单词的翻译及用法，是英语学习的有利工具。