▾

External sources (not reviewed)

The machine's degrees of freedom and the positions of the centers of rotation of the rotary axes are described in [...]

Another function that automatically changes the Z-axis stroke according to the rotation angle of the B-axis made it possible [...]

[...] turns around its own axis but also describes [...] [...]

[...] [...] borescope inspections by automating the process of rotor shaft [...]

[...] heart, as well as a visible red rotor, the patented symbol of Oris High-Mech.

Install pivot plate (A) on pivot and tighten two screws on pivot plate.

The output shaft of the gearbox and the connecting rods experience the effect of the imaginary camshaft by speeding up when the pressure drops (pump lower is at a changeover) [...] [...]

Remove two screws on pivot plate (A), swivel shaft (B) if necessary, and remove coupling (C) from swivel shaft.

[...] [...] aperture onto the rotating mechanism and its two unusual inline oscillating [...]

[...] the Keyway Cutter will self-center onto an existing [...]

[...] requires neither axle nor shaft or gearing.

[...] vertical shaft rotation through gearing, material goes into powder selecting room through feeding port set on the upper of powder selecting machine chamber, and falls on the spreading plate through flux powder pipe and the space between the up cone and the down cone set in the coarse powder collecting cone, and spreading plate rotates follows vertical [...] [...]

[...] [...] accuracy to the rotary axis assembly by [...]

Operate the on-load tap-changer poles separately by one step by rotating the shaft ends counter-clockwise until the diverter switch operates once.

Tag cursors expand the intuitive and interactive display settings like scroll and zoom X and Y axes using your mouse, direct setting of maximum axis value, auto ranging of axis by double-clicking the mouse, axis locking, and axis type that allows you to easily tailor the display to fit your needs.

[...] [...] with an integral rotary shaft seal, a gasket [...] [...]

[...] [...] threaten and may reverse some of the advances achieved since the Fourth Conference [...]

In addition to turning und grinding machines the new combined vertical pick-up Turning and Machining Center VLC 400 MT; from EMAG KOEPFER: the new combined Turning and Hobbing Center VSC 400DUO WF and the new VSC 400 PH gear profiling system for the Power Honing of hardened gears – both vertical pick-up machines with integrated automated workpiece handling.

[...] [...] the Earth’s rotation, to project the [...] [...]

[...] [...] the tilting-type rotary axis and high-precision [...]

Standard techniques for interventional vascular procedures should be employed • Manipulation of the Zilver PTX Drug-Eluting Peripheral Stent requires fluoroscopic control • Do not try to remove the stent from the introducer system before use • Ensure that the red safety lock is not inadvertently removed until final stent release • Deploy the stent over an extra stiff or ultra stiff wire guide • Do not push the hub toward the handle during deployment • Do not expose the delivery system to organic solvents (e.g., alcohol) • Do not use power injection systems with the delivery system • Do not rotate any part of the system during deployment • The device is intended for single use only.