▾

External sources (not reviewed)

Volumetric expansion of each cylinder [...]

Obround and cylindrical tanks use the tank dimensions to calculate tank volume.

Thus, despite the concentration of people near coasts, the majority of land area within the near-coastal zone is relatively sparsely populated.

5.4.5.4 Equipment or volumetric devices used in [...]

If the evaporator and compressor have a large volume, one-sided evacuation may be used, otherwise double-sided evacuation is recommended.

For each installation, the total storage capacity, size and number of tanks need to be related to the size and frequency of intakes, rates of turnover and the number of different products handled etc.

It is apparent that plant closures and technology changes carry no risk of re-conversion, but if the only change is that another solvent is used with the same equipment, a change back to using CTC again would be very easy.

A recommendation is that at least 30% of the shot volume of the machine should be delivered in every shot.

Bible Touch ESV is a simple yet robust native application that includes the entire English Standard Version translation.

At the same time, the compression temperature drops, which allows longer duty cycles and therefore increases the air delivery per hour, while the stroke volume remains the same.

Researchers have shrunk MRI technology down to the nano-scale, allowing the detection and imaging of molecules that are just a few cubic nanometers in volume.

General knowledge of life tells us that when using a pressure cooker to complete cooking the food, the need to put the steam vacuum before opening the lid, then we will find the pot of food is hot, about 100 ℃; when we put a bottom in a container "quick release" valve for thermal spray test, we will find that the temperature of ejecta around the same at 100 ℃; when we used to do test-bed steam explosion process steam explosion experiments, we measured: When using 4Mpa of vapor pressure, steam temperature is 250 ℃ after the explosion, which broke the moment the material temperature in 0.00875 seconds to about 20 ℃ (slightly lower than room temperature), the reaction time has nothing to do with the pressure, volume and number of loading size.

Alterations in LV end-systolic and/or end-diastolic volumes, LV elastic [...] [...]

[...] [...] engine-cylinder volume in order to achieve [...]

If the volume is too large in relation to the part there is a risk of cold flow, which will result in that the maximum strength will not be achieved.

The length of the outage tube determines the amount of vapor space.

Until now, MRI has only been able to resolve structures that are at least a few micrometers in volume, but this advance makes it possible for the medical diagnostic devices to image individual protein molecules.

[...] [...] more floor space than its closest competitor.

The independent but futile presence of the original design has been questioned and rejected thoroughly because it did not allow for any person's right to privacy.

Please bear in mind that the use of a humidifier or a nebulizer will increase the dead space.

Open circuit systems sharing a common reservoir will require greater fluid capacity.

The resistor number itself can be dependent on volume flow, geometry, Reynolds number, etc.

Powered by Spark, Camtek's innovative detection engine, the Orion PX is designed for high end PCB and IC Substrate manufacturers at high volume production sites and provides detection for up to 30um line/space at high throughput.

If the volume should not be displayed in percent but e.g. in l or kg, a scaling can be also set in the menu item "Display".

[...] [...] expansion stage (volume expansion ratio about 10-30%), and in this area the inlet [...] [...]

[...] [...] normal operation in high volumetric load.