▾

External sources (not reviewed)

Secure the gun to the bar by tightening the mounting screw (B).

When you service the piston rod always install new o-rings in the piston rod seal [...]

This option is not available on lower mount or P model gauges and must be factory installed on M model gauges.

[...] [...] the quick release plate and one in the ball stem, always guarantee perfectly [...]

The motor-drive unit must be mounted at the intended position [...] [...]

To avoid damage to the printer caused by printing on the platen, always [...] [...]

[...] washers (3) holding the tie bar to the tie rods (2).

[...] [...] them; spreading and replicating successful examples of alternatives to traditional formal education; encouraging the use of science and technology in order to improve material living conditions in the LDCs; using culture as a political lever for poverty alleviation (promoting artistic creation, developing cultural industries and intellectual property rights); and fostering the development of LDCs and their access to ICTs”.

[...] [...] that includes a telescopic arm, a +/- 90° tilting [...] [...]

[...] line accessories and use it to isolate them during cleaning [...]

[...] instructions on removal and reinstallation.

Mexican authorities reported that the vast majority of cannabis herb exiting, as well as entering, its territory was smuggled by land; once dried, the cannabis herb was packed in plastic bags with the help of presses and hydraulic jacks and then transported to illicit markets, both in Mexico and in other countries.

[...] connecting rod (205), or pump (206) were removed, reassemble rod in housing [...]

The tap selector terminals are indicated on the tap selector bars.

[...] healds on heald carrying rods and efficiently avoids [...]

[...] [...] accidents or safety failures connected with the [...] [...]

[...] [...] the number of a free helpline were printed on food packages; and experienced professionals [...] [...]

[...] handle its construction ensures a firm hold of the rod.

The tap position is recorded by a resolver (rotation angle sender) which is mounted on the position [...] [...]

Plain packaging may also serve to enhance the [...] [...]

[...] [...] policemen, at least one of whom was armed, stopped Mr. Bozano as he was [...] [...]

The Base Bolt Tensioner, designed specifically for the wind energy market, eliminates any potential thread fit problems by utilising the existing hex nut on the stressing bar in order to induce the required load.

Recommendations proposed included prioritizing least developed countries in allocations of official development assistance; implementing new and innovative sources of financing; exploring and, where possible, experimenting with new types of financial and, especially, non-financial collaboration; leveraging resources through subsidies for international private sector engagement, especially foreign direct investment, in areas of least developed country priority; strengthening least developed country capacities for commercial contracting through greater transparency in agreements and by fostering governmental, especially parliamentary, review; increasing the participation of least developed countries in governance of the aid architecture.

Ancillary facilities such as wheelchair space with back rest and restraint lap belt, front kneeling capability with wide entrance, high colour contrast and textured handrail system inside compartment, super low floor covered with non-slippery floor material, easily reached bell; priority seats for passengers with disabilities, large electronic destination and route number display on the front, large electronic route number display on the side and rear, closing door buzzer and warning lamp at exit and Braille registration number plate and customer service hotline inside compartment are equipped in most buses to facilitate persons with disabilities in using bus services.

[...] [...] used for applications installed on local machines that [...] [...]