| 单词 | flow stress |
| 释义 | 例句释义: 流动应力,屈服应力,流变应力,流度应力,怜应力,低的流变应力 1. Since the yield (flow) stress of the material decreases, in general, with temperature, inelastic deformation will most likely take place. 自从产量（流）的应力降低，普通状况下，资料温度、无弹性变形就极有可能会发作。 hi.tt40.cn 2. Experimental results showed that the DCPs could increase the elongation rate remarkably, whereas only decreased the flow stress slightly. 结果表明：脉冲电流能显著提高7475铝合金的伸长率，稍微降低其变形流动应力。 www.ceps.com.tw 3. The results showed that the flow stress and deformed microstructure were greatly affected by strain rate and deformation temperature. 结果表明：应变速率和变形温度对合金的流变应力与变形组织有显著影响。 www.rm-journal.com 4. The results show that the flow stress decreases with the deformation temperature increasing and strain rate decreasing. 结果表明：合金的流变应力随着变形温度的升高和应变速率的降低而降低； www.rmme.ac.cn 5. The results showed that the flow stress of UFG CP-Ti would change significantly with the thermal compression conditions. 结果表明：超细晶工业纯钛在热压缩过程中，热压缩条件不同流动应力变化规律会有所差异。 www.rm-journal.com 6. The results show that flow stress increase with the increase of strain rate, while decrease with the increase of deforming temperature. 研究表明流动应力随应变速率的升高而增大，随变形温度的升高而减小。 www.ceps.com.tw 7. The main factor influencing computational accuracy of rolling load is the accuracy of material's flow stress. 分析了影响轧制力计算精度的主要原因，即来源于流动应力的准确性。 www.dictall.com 8. When deformation temperature is constant, flow stress increases with the increase of strain rate. 当温度一定时，流变应力随着应变速率的升高而增大。 www.rjggy.net 9. When strain rate is constant, flow stress decreases with the increase of deformation temperature. 当应变速率一定时，流变应力随变形温度的升高而降低； www.rjggy.net 10. The effect of annealing on peak flow stress of cold rolled sheet was little. Cold rolled sheet could be hot formed directly. 退火处理对冷轧板的峰值流变应力影响较小，冷轧板可直接用于热加工成形。 www.ceps.com.tw 1. Finally, the constitutive equation for flow stress of 7A85 aluminum alloy at high temperature is obtained by linear regression. 采用线性回归方法获得了7A85铝合金高温条件下流变应力的本构方程。 rjggy.net 2. The corrected flow stress is generally higher than the uncorrected at the same strain rates and strain. 在相同应变速率、相同应变下，修正的应力要高于未修正的应力。 rjggy.net 3. Effect of strain rates on peak flow stress is relate to deformation temperature. 应变速率对峰值应力的影响与变形温度有关。 www.chemyq.com 4. The flow stress was strongly influence by the grain size. 晶粒尺寸强烈影响合金的强度。 www.chemyq.com 5. The effect of the deformation temperature on flow stress is related to strain rate. 而变形温度对流动应力的影响程度与应变速率的大小有关。 www.ceps.com.tw 6. Molybdenum is strain rate sensitive material, that is, flow stress increases with increasing strain rate. 金属钼是正应变速率敏感性材料，即流变应力随着变形速率的增加而增大。 www.fabiao.net 7. Review on Mathematical Modeling of Evolutions of Microstructure and Flow Stress in Austenite Stainless Steels during the Hot Rolling Process 奥氏体不锈钢热轧加工性能的数学模型研究 www.ilib.cn 8. Prediction of the flow stress of a titanium alloy during hot deformation 钛合金高温变形流变应力的预测 www.ilib.cn 9. Flow stress and constitutive model of OFHC Cu for large deformation, different temperatures and different strain rates 高导无氧铜在大变形、不同温度和不同应变率下的流动应力和本构模型 168.160.184.82:8080 10. Artificial Neural Networks Models for Flow Stress during High Temperature Plastic Deformation of Al-Li Alloy 铝锂合金高温变形流变应力的人工神经网络模型 www.ilib.cn 1. Application of a Hybrid Model in the Prediction of the Flow Stress of 30 MnSi Steel 一种混合模型在30MnSi钢变形抗力预测中的应用 www.ilib.cn 2. Finite Analysis of Temperature Field and Prediction of Mean Flow Stress during Multi-Pass Hot Strip Rolling 热连轧带钢温度场有限元分析和平均流变应力的预测 scholar.ilib.cn 3. Flow Stress Prediction With Dynamic BP Networks and Mathematical Models in Hot Rolling 运用动态BP网络和数学模型预测热轧变形抗力 www.ilib.cn 4. Flow stress characteristics of isothermal deformation at high temperature for 7075 aluminum alloy 7075铝合金高温等温变形的流变应力特征 www.ilib.cn 5. Flow Stress Characteristics and Constitutive Equation at High Temperature for 7050 Aluminum Alloy 铝合金7050高温流变应力特征及本构方程 www.ilib.cn 6. Experimental Study on Coupling of Flow-Stress within a Single Fracture 单裂隙流-固耦合渗流的试验研究 www.ilib.cn 7. Effect of Relative Grain Size on the Flow Stress of Polycrystalline FCC Sheets in Simple Tension Test 晶粒相对尺寸对FCC多晶体板材单向拉伸流动应力的影响 www.ilib.cn 8. Flow stress of high-strength weldable 2195 aluminium-lithium alloy during hot compression deformation 高强可焊2195铝-锂合金热压缩变形的流变应力 www.ilib.cn 9. A Influence of the Metal Flow Stress Model to FEM Numerical Simulation 金属材料流动应力模型对有限元仿真结果的影响 www.ilib.cn 10. Flow Stress Mathematical Models of Stainless at Hot Deformation 不锈钢热变形流动应力数学模型 www.ilib.cn 1. The Numerical Simulation of Decreasing Flow Stress Scale Effect 流动应力下降尺度效应的数值模拟 www.ilib.cn 2. Current biggest problem or a cotton yarn for textile enterprise sales difficulties, cash flow stress; 目前纺织企业面临的最大问题还是棉纱销售困难，资金周转紧张； www.texclo.net 3. Prediction of Material Flow Stress in Warm Forging with BP Neural Network 利用BP神经网络预测材料温锻流动应力 www.ilib.cn 4. Prediction of Flow Stress for Low-Carbon Steel in Low Temperature Region 低碳钢低温区流变应力的预测 www.ilib.cn 5. Flow Stress Behavior and Dynamic Recrystallization of 3104 Aluminum Alloy 3104铝合金的流变应力行为与动态再结晶 www.ilib.cn 6. Prediction of metal flow stress by neural network 基于神经网络的金属变形抗力预测 service.ilib.cn 7. A Mathematical Model Based on Grain Size for Flow Stress of Structural Steel under Hot Deformation 基于晶粒尺寸的结构钢热变形流变应力数学模型 www.ilib.cn 8. Hot-rolled micro-alloyed steel austenite gain size and flow stress model based on Neural Networks 基于神经网络的微合金钢热轧奥氏体晶粒尺寸及流变应力模型的研究 www.ilib.cn 9. The Scale Effect of Flow Stress Fluctuation in Micro Scale 微小尺度流动应力波动尺度效应 www.ilib.cn 10. Study on Flow Stress of Aluminum at Hot Deformation 工业纯铝热变形流动应力的研究 www.ilib.cn 1. Modelling for grain size and flow stress of magnesium alloy based on BP neural network 基于BP神经网络的镁合金晶粒尺寸及流变应力模型 service.ilib.cn 2. Effect of strain rates on flow stress feature of 7075 aluminum alloy 变形速率对7075铝合金流变应力的影响 www.ilib.cn 3. Prediction of Metal Flow Stress Based on RBF Neural Network 基于RBF神经网络的热轧碳钢变形抗力预测 www.ilib.cn |
| 随便看 |
|
英汉双解词典包含2704715条英汉词条，基本涵盖了全部常用单词的翻译及用法，是英语学习的有利工具。