floppy drive

I saw a lady at work today putting a credit card into her floppy drive and pulling it out very quickly.

I ran the program under an emulator, writing the data to a USB floppy drive plugged into a Mac.

This floppy drive is not supported. The files will have to be copied manually.

If you want mount to automatically determine the type, specify auto as is done in the last line of Listing 9 for the floppy drive.

The Home Networking wizard did not find a floppy drive on your computer.

A floppy drive cannot be specified as an install location.

When Mini-Setup starts, it looks at the floppy drive to see if a Sysprep. Inf file is there.

A network connection may have been lost, the floppy drive door may be open, or the floppy drive may contain the wrong disk .

Floppy group can be used locally to give a set of users access to a floppy drive.

The selected floppy drive is unable to support the required media type.

Booting from the boot floppy is supported only for Atari and VME with a SCSI floppy drive on VME at this time.

The floppy drive is also an IDE device, but its cable is narrower than the ones used to attach the CDROM and hard drive.

A floppy drive is usually (fd0).

Select the type of floppy drive connected to the system.

When talking about the different disk drives, you say 'Drive A' for the floppy drive, but normally write 'A: '.

If you selected Floppy drive or other removable media, you are prompted to insert disk 1 and then click OK.

After installation is complete, close the floppy drive Explorer window.

drives installed, mainly for the hard disk, CD-ROM and floppy drive installed.

Main camera, optical drive, floppy drive, computer motherboards, mouse and other products.

Boot a computer with the floppy disk image (use a USB floppy drive if the computer does not have one).

Insert the backup of Disk 1 that you created in into the floppy drive.

The drive specified is not a floppy drive.

The floppy drive controller may be faulty.

The floppy drive device reads and writes data to and from floppy disks.

Click the transfer method that you want to use, for example, Floppy drive or other removable media, and then click Next.

Please remove the client setup disk from your floppy drive now.

Image File Mount image file to virtual Floppy drive.

The floppy drive controller cable is twisted at one end and split near the middle.

Enter floppy drive with SATA drivers and press S.

Cannot access floppy or floppy drive.

No floppy drive available. The ASR recovery diskette can not be created. Please refer to the on-line help for further assistance.

Error copying files to floppy drive.

No floppy drive was detected.

If you have a USB floppy drive or some other unusual type of floppy drive, select it from the list.

Please insert a floppy and make sure that you have selected a valid floppy drive.

There is no disk in the floppy drive or the drive door is not closed. Please make sure that the floppy drive is ready, then try again

You can now unmount the floppy drive (as root) to get the disk out with

My Edited Software to Revise the head of Floppy Drive

Windows 2000 assigns duplicate drive letters to a single USB floppy drive

Windows 2000 Patch: Data Corruption Accessing Floppy Drive During Heavy System Load

Place a good, blank floppy in the floppy drive. Next, use the command

Use Floppy Drive Contents As Master File List,

Please specify the floppy drive to copy the images to

Scan floppy drive at startup

You may receive a "Stop 0x23" error message after you remove a USB floppy drive cable from a Windows Server 2003-based computer