floorman

The floormen remove the front cover of the drawworks first.

The floormen spin out the connection using the air spinner, or if applicable, the driller utilizes the top drive to spin out the connection.

Two floormen, located at the new drilling line spool, are to reeve off the drilling line without delay.

Upon the driller's instruction, the floormen tighten and torque the nuts on the dead line anchor clamp with the socket torque wrench.

Some floormen like to pull out of hole, and others like to run in hole.

After the connection has been tighten to proper torque, the Floormen remove the rig tongs and tie them safely out of the way.

The floormen must be instructed on proper placement of hands while operating the rig tongs.

The Floormen remove the rig tongs and tie them back safely out of the way.

The Floormen must be instructed on proper placement of handswhellole operating the rig tongs.

The floormen will not to work tomorrow.

The Floormen apply proper pipe dope into the thread box of the pipe joint.

The floormen reinstall the guards over the draw works drum.

The floormen tighten the weight indicator diaphragm clamps back on the dead line.

The floormen had laid down the pipes before they ate lunch.

The floormen unwinds sufficient drilling line (about 15 meters) from the storage spool.

The Floormen set the slips and the Driller picks up a joint or a stand of pipe.

After the drilling line has been cut, the floormen pull remaining fast line cut of the way.

The Floormen make the rig tongs bite by pulling on the tong jaw and pushing on the tong arm.

The Floormen make the rig tongs bite by pulling on the tong jaw and pushellong on the tong arm.

Two floormen secure the fast line on one side of the drawworks.

The Floormen must lubricate rig tongs at regular intervals, and always before and after each trip