bearing load

If transition at the shaft collar of a circular shaft adopting closed angle will bring biggish stress concentration as bearing load.

In crowd- pile foundation design, the general idea thinks all the load bearing by piles and not considering the interpile soil bearing load.

The value and direction of the static steam force change a lot in different performance cases, which change bearing load directly.

If the actual load is a combined radial and axial load , then an equivalent static bearing load must be calculated .

In fact that hull girder deflection could greatly affect the bearing load, so the calculation must take it into consideration.

The maximum load that can occur on a bearing should be used in the calculation of the equivalent static bearing load .

but it will influence the magnitude and distribution of the main bearing load.

In all other cases it is first necessary to calculate the equivalent dynamic bearing load.

When constructs the load-bearing load cannot withstand cannot use the stone material ground.

The resulting increased bearing load shortens bearing service life.

The allowable pile bearing load is prestimated, And The outcome is in conformity to static pile test.

Channel is bearing load of work surface, so the channel design and machining is particularly important.

In all other cases it is necessary to first calculate the equivalent dynamic bearing load.

At the same time, because of double screw compressor stress is bad, bearing load, its mechanical noise than single screw compressor.

Experiment Study on the Long-Term Stability of Bearing Load Cell in large turbine- generator sets

The magnitude of the specific bearing load can be determined using

Relationship between Amplitude of Steam Turbine Generator and Bearing Load and Oil File Stiffness

Influence on bearing load of ring-plate-typed pin-cycloidal epicyclic drive affect by machining error

Analysis of Bearing Load of an Inline Six Staggers Crankshaft

Dynamic bearing loads - Equivalent dynamic bearing load

Analysis of Bearing Load and Settlement of the Reinforced Ground

Application of Testing Method for Self-balance of Bearing Load Capacity of Pile in Cang Er-zong Bridge

Selection of bearing size - Equivalent dynamic bearing load

Selecting bearing size using the static load carrying capacity - Equivalent static bearing load

A Calculation Of Bearing Load Sensitivity In Large Turbine-Generator Sets

Bearing load distribution and bearing clearance

Selection of bearing size - Equivalent static bearing load

Utilization of module fired perforated bearing-load brick

Computation and Analysis of Bearing Load Capacity of Piles for High-pile Wharf

Calculation and Test of Bearing Load Capacity of Piles for Used High-pile Wharf

Study on Calculation of Crankshaft Deformation and Bearing Load Based on Whole Crankshaft Beam-element Method

Selection of bearing size - Specific bearing load

Cranes; determination of bearing load of crane rail wheels

Oil Film Bearing Load Distribution On-Line Test for High Speed Wire-Rod Mill

Influence number of bearing load

The equivalent dynamic bearing load is obtained from

The Finite Element Analysis on Bridge Bearing Load Cell

Analysis of bearing load features for arch support

Bearing Load Identification of No. 4 Turbine Generator in Qinling Power Plant

Study on the Load Cell for Bearing Load Measurement