driller

The company is still the leading driller in the Gulf, and operates more leases there than any other company.

The Senior Driller must ensure that the correct bit, dressed with appropriate size jets, is ready to be picked up.

Observed damage on or to any equipment will be recorded in the tour book and reported to the Driller and the Toolpusher.

Photo 1 - Going to the front of the tunnel and discuss with the driller to provide enough ground support to the exposed rock face.

The driller is to trip off bottom and out of the hole at a speed that will not cause swabbing.

"If I were going to buy any energy stock now I'd rather buy a producer or a driller, " he said.

He worked in the merchant navy, as an oil driller in India, a cow herder in Israel and a doctor of Chinese medicine in Thailand.

When scientists artificially increased calmodulin in chicken embryos, the chicks began growing extended beaks, just like a cactus driller.

The driller checks the end of the new drilling line for damage, and cut off any defective section by using of a hydraulic line cutter.

Clean and examine the threads and shoulders on box and pin ends, and inform the Driller of any damage.

Firstly, the driller rig is introduced, then the general control structure is designed.

F. Practice has been proved that the taphole driller has good economic results and can be substituted for the imported taphole driller.

And landowners keep wallowing in royalties whether the driller makes a profit or not.

The floormen spin out the connection using the air spinner, or if applicable, the driller utilizes the top drive to spin out the connection.

When I was a driller, he was as a motorman.

A clutched, rotating spool that enables the driller to use the drawworks motor to apply tension to a chain connected to the makeup tongs.

The driller must ensure that the drilling line is reeved in under tension and that the drilling line is properly seated in the drum grooves.

In the case of an underbalanced kick, the driller must circulate the influx out and increase the density of the drilling fluid.

The driller slowly hangs off the traveling block or top drive in accordance with the derrickman's or floorman's signal.

Upon the driller's instruction, the floormen tighten and torque the nuts on the dead line anchor clamp with the socket torque wrench.

The king of the oilfield is the driller. he is a very skilled man. Sometimes he sends is drill more than a mile into the earth.

Torque signals collected contain adequate engineering information, helping driller monitor drilling conditions and detect danger in time.

After the rig crew places the slips around the drill pipe and in the rotary, the driller slowly lowers the drill string.

The derrick man, positioned at the crown block, is to advise the driller when the snake is coming through the crown sheave.

Drilling experiments are also done to test the performance of this ultrasonic driller.

The oil and gas driller can send seismic waves miles under the sea floor, gather the echoes, and deduce whether petroleum might exist there.

Lead and backup tong-men should not stand between the two pipe tongs while the driller is making up or breaking out pipe or collars.

He had worked as a driller in another crew for five years before he came to our crew.

Driller can show them to be part of the drilling system.

When all personnel are ready, the driller engages the drawworks in forward drive and starts reeving in the new drilling line.

The driller's view of the drill pipe in the rotary table should not be obstructed at any time.

The user should read this operation manual carefully before operating the pipe driller machine.

The paper carries out the research on optimization design for power unit of full driller.

Works as a trainee driller as well as fulfill the job assigned by the project manager.

It was not decided then who would work as a driller.

While we were repairing the pump , the driller was working drill pipe .

Verify the grade of the drill pipe, measure length, record and inform the Driller.

Auto-slips may be installed at the driller's discretion after there is sufficient hanging weight to prevent accidental opening.

This research provides an important reference value for design of power unit of full-driller.

The Driller ensures that the safety latch springs are replaced on the tong pins.

Sometimes, he also operates the handle and manages the roughnecks instead of the driller.

The Driller is to ensure all rig tongs have two snub lines attached for safety.

For measurements-while-drilling, the reference is the bit (the driller's depth).

The floor men set slips, or where applicable, the driller sets the automatic slips.

He is an assistant driller. He is not a driller.

"Good morning, Mr. Chen? " he greeted the driller who was holding the brake handle.

The king of the oilfield is the driller. He is a very skilled man.

The driller does not work in the office; he works on the drill floor.

The interval is too long. I'm afraid . Could you deliver the driller sooner?

The driller is authorized to shut in the well when situation indicates.

Full-driller is a drilling rig for oil exploration and drilling.

The driller then resumes normal operations.

The driller also operates the drawworks brake using a long-handled lever.

Driller and hydraulic damper operator shall cooperate each other to make the mast lifting in servocontrol with the hydraulic damper.

The Driller shall ensure that all gauges and sensors, such as the weight indicator, torque gauge, are inspected and calibrated.

The Floormen set the slips and the Driller picks up a joint or a stand of pipe.

The driller and the derrick man must remain in constant radio contact.

The driller must log on the trip sheet, and record the following situation in the tour book.

There are two roughnecks helping the driller get everything pretext ady for running in hole.

The driller sets the drill string in the slips (or on the elevator).

The driller filled the grill with brilliant film.

There are two roughnecks helping the driller get everything ready for running in hole.

Set a sign board and inform the driller when you do something repairing.

Last year he told me that he would work as a driller.

The driller sets the drill string in the slips or elevator.

Our hard-working driller is someone you can believe in.

The driller filled the grill with superb film.

I'm not a driller of this crew.

Mr. Driller Ace - Strange Beria.

He has worked as a driller in that crew for nine years.

The new type of the medicinal driller, based on microcontroller MCS 51 and step motor is presented.

He works as a driller in this crew.

When did you begin to work as a driller?

Working with tools, like saw, driller, or a screw driver.

I'm a driller. You are a roughneck.

Kill the well using the driller's method.

He is a driller whom you can believe in.

The driller disengages the drum clutch when there is 1 or 2 wraps left on the drum.

Taphole driller is a key equipment to open the taphole blast furnace.

I have been a driller for ten years.

Improvement of the Head Parts and the Torsional Frameworks for a Diesel Rock Driller

This driller works harder than that one.

Research on Method Applying Wavelet Conversion to Improve Efficiency and Accuracy in Monitoring State of Driller

He is a driller whose opinions I like to accept.

Discussion and Practice for Promoting the Certified Rate of Thermoplastic Formation Rolling Driller

New construction technology of drilling through yellow river riverbed by horizontally directional driller

Circulating water-colling system Drawworks driving DC motor Automatic Driller motor Automatic Driller Unit Crown block

The Characteristic Analysis of Rotary- cutting and Move-in Automatic Coordinated Hydraulic Anchor Arm Driller

Analysis of Structural Feature and Developmental Tendency of Swing Driller at Home and Abroad

Application of Horizontal Directional Driller in Accurate Locating of the Pipe

Discussion about troubles of carriage in horizontally directional driller

The Application of the Hollow "Primary-secondary" Driller in the Treatment of the Broken Piles

Some ways of the application and fault removing of the air-leg driller

Analysis of flow pressure properties of hydraulic system in a bench driller

Design and application of the drilling drawworks controller and driller's house

Application of the screwing and scooping driller in the bored pile construction

Study on Ultrasonic Driller for Microstructure Manufacture

Reconstruction and Application of Hydraulic Cooling System on Patio Driller

driller aiguilles and electric drill (remark: customer provide)

Research of the control and communication on five-coordinate NC driller

Realization of Control and Communication Between PC and Five-Coordinate NC Driller

Actual State Analytic Method about Tool Clamping Error of Driller Clamping Fixture

Shallow Analysis on Power Source Configuration of Hydraulic Road Driller

Exploiture of screwthread driller and its application

Analysis on the Construction Piling with Percussion Driller

Construction technology for under-reamed bored pile by rotary driller

Experimental Study on the Performance of Titanium Alloy Deep-hole Driller

Performance Indexes and Measuring Method of Pneumatic Bolt Driller

Construction process of spiral digging driller and quality control

Optimal design of transmission device in the concrete driller

Ways of Treating the Flowing Sand in the Manpower Hole-driller Engineering

Scheme design of motor-regulated automatic feed driller

Application of impacting driller to basement

Correct Operation Of Driller And Miller To Machining Pipe Plate

Killing Simulation of Driller's Method in Deep Water Well Control

Screened, electric driller cables for mine

Analysis on hydraulic system of hydraulic bolt driller - pump

Developing of Void-Cut Position Sensor for Micro NC Driller

Research and development of new drilling bit for roof bolt driller

Application of DSP in Motor Controlling of Driller

Application of LM-200 type inverted driller in Gaoqiao hydropower station

Research on Overhead Driller for Roof Control

The Application and Fault Removing of Air-leg Driller

Design of driller control house of drilling rig

The Work Space Design for Driller Control Cab

The Design of Foam Drilling and Truck Driller

Pile boring with BG Rotary Driller Series

Development of hydraulic coal driller

Optimal Design of Driller'Gear Box Based on the Method of Grey Classification

Development of a New Medicinal Driller Based on MCS-51 Microcontroller