elastic limit

The change at the elastic limit from elastic to plastic deformation is referred to as the yield point or yield strength.

For a solid, the strain is a function of the applied stress, providing that the elastic limit is not exceeded.

When a material is stressed beyond the elastic limit a permanent deformation results.

Normally torsion bar spring has high elastic limit, fatigue limit, impact toughness and good heat treatment performance.

If the stress on a material exceeds its elastic limit then it is permanently strained, the latter being brought about by plastic flow.

Apply enough force, though, and you will go past what is known as the elastic limit and the object will be deformed permanently.

e. When a material is stressed yong the elastic limit a permanent deformation results.

The ecological elastic limit showed downtrend wholly, but whose decreasing range was lessen.

the working stresses should be below the elastic limit of the material.

Modulus of elasticity is the ratio of stress to strain within the elastic limit.

For this reason, other measures of stress that can be used as a practical elastic limit are required.

Once loads exceeds the elastic limit, materials fail to recover their original shapes.

When a material is stressed byong the elastic limit a permaent deformation results.

The elastic limit is the maximum stress for which the material acts elastically .

Plain bearings. Metallic thin-walled half bearings. Determination of the sigma 0, 01 elastic limit.

once the strain exceeded the elastic limit, the dislocations began at the stress concentration position of the hole;

Calculation of elastic limit point of steel tube concrete column axial pressure

Study on elastic limit and relevant enclasp force of non-precious metal casting clasp

The Elastic Limit and the Relevant Enclasp Force of Non-Precious Metal Wrought Wire Clasp

elastic limit, Yeung''s module of elasticity to yield point

stresses beyond the elastic limit