cylinder wall

The main section of a piston is known as the skirts. It forms a bearing area in contact with the cylinder wall.

The heat damage led to cracking through the cylinder wall. Salvage was not possible.

In the two-cycle engine, the piston ACTS as a valve, clearing valve ports in the cylinder wall as it nears BDC.

The repeated measurement data to cylinder wall at the same location , basically described the same change of degree of uniformity.

For most engines, cast iron has been found to be a satisfactory cylinder-wall material.

The oil -control rings scrape off excessive oil from the cylinder wall and return it to the oil pan .

And against the cylinder wall damping hole layout was designed with high usability.

It is equipped with piston rings to provide a good seal between the cylinder wall and piston.

Bionic mosquito gas is carbon dioxide gas and cylinder wall coating on a mixture of substances.

Lo screw slot chassis (cylinder) wall and stars constitute a closed volume of the tooth.

Some connecting rods have an oil spurt hole in the yoke or at the cap-mating surface to provide cylinder wall lubrication.

All the while, the piston's sides, or skirts, slide against the cylinder wall.

It can improve the lubrication performance between cylinder liner and piston rings and enhance the rigidity of cylinder wall farthest.

merit: The zinc cylinder wall is thick, after chemical reaction, does not perforate, leakproof fluid;

Comparison of the two processing methods of the cylinder wall: laser quenching and laser honing

Construction of Conic Cooling Tower Concrete Cylinder Wall

For the production of titanium cylinder wall dryer;

The new processing method of the cylinder wall: laser honing

Numerical Simulation of Heat Transfer in Cylinder Wall of I. C. Engines

the cylinder wall is fixed on the base by inserting buckles;

Cooling Effect on Cylinder Wall of Compressor