cutting knife

Even snap to cut knife, because at this point cutting knife from pressure is too large to front end.

die-cutting knife around the paste too dilute rubberand or rubberand of the hardness of small, there is not enough to cause rebound.

The utility model provides a rubber belt box with a cutting knife, the cutting head can be found at any moment.

the surface temperature of the blade of the cutting knife is maintained lower than 40 DEG C.

To slice, tip the cutting knife up on an angle, to use the far end (away from you) of the blade.

In particular, pressure-sensitive trade mark die-cutting, with no precision die-cutting knife at all.

Intracavernous is too soft, then you cannot make the paper smooth out of die-cutting knife or indentation line the powder.

Stroke using electronic circuit control, convenient adjustment with cutting knife discretion and trace regulator, the most accurate.

the paper cutting knife: in business card paper to cut paper chekanovskogo operation cannot be performed.

Die-cutting is the core of the die-cutting, and die-cutting, and die-cutting knife, indentation line is the basic parts die-cutting.

Therefore, whenever you want to be correct and clamping pressure to prevent cutting knife due large deviation.

If the answer to die-cutting on gift box, the indentation of Telegraph and die-cutting knife at the intersection of burst's fault.

Applicable to cutting knife wheel, glass of blade is specially the mirror processing edm, cutting line especially beautiful.

Specially set structure to fit the cutting knife and cutting height, contributing to simple and accurate travel adjustment.

A cutting blade is fixed on the cutting knife rest. A transmission gear is fixed on the cutting knife rest and the cloth-supplying drum.

Cutting is performed by the paper-cutting knife driven by the motor via a gear transmissi The paper pusher moves back and fonh rapidly .

The height of the die cutting knife for cutting the packaging materials.

Can use double-sided sharp cutting knife, the savings artificial and cost.

Setting of the cutting knife is simple and accurate.

Dprcoally set struvture to fit the cutting knife and cutting height, contributing to simple and accurate travel adjustment.

To resolve this issue in the first place according to the selection of different types of paper-cutting knife.

Because the sponge should provide sufficient hardness to squeeze paper, let die-cutting knife smoothly move the paper.

Change the various forms of cutting knife.

Solution: First, we must choose different types of paper cutting knife.

In order to guarantee cutting knife to cut to the lateral tangential location, need to adjust the horizontal position of the paper.

6 b. 3 cutting device is mainly by drawing roller, cutting knife, knives, exchange and transmission gear system, etc.

In the Assembly, the hinge-drum of cutting knife pads should be cut to 5. 1 serrated cutting knife.

Two: start work: press the power switch, conveyor belt and cutting knife started work at the same time.

a cutting knife device is arranged on the front section of the stand through a straight-line guide rail;

This fault causes are: die-cutting knife around the pasted sponge mrtomated hardness density is too small or too small, rebound;

Improvement on Material Cutting Knife Used in Vertical Pressure Machine

Renew the Concept of Using the Paper Cutting Knife in Printing Industry

When the device is put into operation, firstly the hylum cutting knife cuts the hylum of the water chestnut to rift cut the hylum;

II the paper tape in the hinge-cylinder cutting knife cut drum pads and trimmed blocks by, saw-tooth cutting knife to cut into leaflets;

Domestic research of cutting knife on polymer pelletizing

Automotive cutting knife switching device of brake cup cutter

Auto Change-over Cutting Knife Applied for Leather Cup Cutting Machine

Rational installation of veneer cutting knife and the veneer quality