curing time

Modifying the curing process according to the result of the kinetic study, we are able to reduce the curing time designed by Huang in 2001.

Statistical techniques were utilized to evaluate the repeatability of these devices and their sensitivity to curing time.

Curing Time : The time needed to complete curing of an epoxy at a certain temperature .

The composition provides improved and reproducible flow during the early stages of molding without compromising curing time.

The influence factors on surface curing time of silicone rubber release agent vulcanized at room temperature were analyzed by experiments.

The properties of the composite at different curing time have been tested and the best curing time obtained.

With the increase of curing time, the strength of cementitious stone increases continually in later period.

With glue and gummed, as adhesive flowability of hot melts, stickiness lower, good opening hours curing time long, high bond strength.

The cooling time, known as the curing time.

The hardness and resistance to the corrosion can both be improved with the increasement of curing time.

the second was to extend the coating and curing time fully-levelling and curing.

In conjunction with adhesive curing time refers to the solidification process.

Effects of graphite content, curing time and curing temperature on the properties of the composite were studied with orthogonal test.

Unconfined compression strength and the E50 increase with the contain of slag cement and admixtures, and increase with curing time.

User regulator and curing time points at the same time, the user point surge coverage curing point, namely, the principle of user settings.

The peak strain decrease with the contain of slag cement and admixtures and curing time.

Curing time can be reduced, since a short filling time enables us to use a fast curing encapsulant.

The effects of water-binder ratio, content of fly ash, type of fly ash, and curing time on strength of mortar.

Hotmelts, under a different model has long curing time, should be based on a short season, rational choice.

And the influence of levels of Co, K and rare earth metals on the properties of unsaturated polyester resin, such as curing time, g. . .

It can be quicky cured and resisted high temperature for class H in a short curing time and low evaporation losses.

And the curing time is dependent on the speed of light pressure.

The speed that is, pressure on the calendaring of curing time.

Curing time according to the hot melts of a different model, there is a short, General curing time is 3 to 5 minutes.

Hot melt Adhesive curing time is approximately 3-5 minutes. (2) the hot melts press the paper.

In addition, make master hot melts of curing time, because the thin glue to the books behind, but also for 3 to 5 minutes to Basic.

The results showed that the curing time of product extended when the heat diffusivity decreased;

Analysis of the influence factors on surface curing time of silicone rubber release agent vulcanized at room-temperature

Studies on the Relationship between Castanopsis hystrix Wood Properties and Curing Time of UF

Experimental Study of Influencing Factors of Cement Curing Time

Effect of hot-pressing temperature and natural curing time on properties of fast-curing cement particle board

Anticipation of Curing Time at Ambient Temperature

Influence of curing time on structure and properties of SBR ebonite

The Influence of Curing Liquid and Curing Time on the Quality of Dried Beef

Antimildew, anti-alga under the high temperature, high humidity and more glucide surroundings, Can adjust the curing time;

The influence of the burl wood on the curing time of UF in three kinds of the hardwood

Effect of curing time in mold on the properties of low cement corundum castable