child seat

Push your weight into the child seat as you tighten the seat belt to make sure the child seat is securely held.

It is usually not possible to be certain of the history of a second-hand child seat.

One of the most common fitting mistakes is to leave the child seat held loosely by the seat belt.

Ask your local Road Safety Department (part of your Council) whether they know of any child seat discount schemes.

If the seat belt buckle lies across the frame of the child seat it will be under pressure and may spring open in an impact.

But it was necessary because it had the child seat attached to the back.

Check with the child seat and car manufacturers that the child seat is suitable for your car.

If the movie without their parents of the child seat to play, parents may request the film off the air.

Make sure the child seat has been fitted according to the manufacturer's instructions and that the harness is not twisted or tangled.

Check that the seatbelt buckle is not resting on the child seat frame (this is known as 'buckle crunch').

The child seat should be securely held to maximise the distance between the child and the airbag.

The support member supports the child seat such that the support member can swing and jump opposite to the framework.

If the child seat has an 'alternative belt route' for use with shorter seats belts, see if this route avoids the buckle crunch.

For instance, if the anchor point is too far forward, it may not be possible to hold a particular child seat firmly in the car seat.

The passenger's side safe ball could be locked by the lock of the central penal , in order to install the child seat back forward.

Make sure the seatbelt passes through all the correct guides on the child seat.

Without them, it is difficult to be sure that the child seat has been correctly fitted.

Standard connectors attach the child seat firmly to the vehicle body.

Try the child seat in other positions in the car to see if there is a better fit.

Sometimes the position or design of the seat belt anchor points make it difficult to fit a child seat securely.

The child seat should rest firmly on the car seat, with hardly any forwards or sideways movement.

A child seat is coupled to the carrier and positionable such that feet of an occupant of the seat can contact a launching surface.

If you use the child seat in more than one car, follow the advice below for each car.

If you are unsure about anything, seek advice and if possible get someone to check the fitting of child seat for you.

Small children need to be in a special child seat at the back.

Replace any child seat that was in a car at the time of an accident.

For the young children , rear-forward child seat may improve the protection effect for head and neck.

Check that the child seat rests on the car seat properly.

Front passenger airbag can be deactivated to allow fitting of child seat.

Keep the fitting instructions with the child seat in the car.

Then use as a seat with backrest increase from 15 to 36 kg, which kid is on the 3-point belt of the vehicle in the child seat buckled.

If a child seat cannot rest properly on the car seat, it will be difficult to hold the child seat securely.

Good thing Gabe wasn't in the child seat!

If a child is too big for their child seat, it will not protect them properly and may even injure them in a crash.

Avoid buying a child seat by mail order, unless you are sure that it will fit your car.

A particularly advantageous fact is that the child seat can be used with 2-or 3-point seat belt.

Here is a list of suggestions for preventing your child from escaping from their child seat during a journey.

If you have lost the instructions, contact the child seat manufacturer to check if they can provide a copy.

Only buy a new child seat.

Passenger Airbag Cutoff Sensor Activated By Passenger Weight or Installed Child Seat

Please note, the integrated child seat is positioned behind the driver's seat