yield stress

Cyclophosphamide innovative ink stickiness or yield stress is too high, resulting in a transfer of the poor.

Thus cubic particle model can predict the minimum current density of a certain ER fluids needed to obtain a shear yield stress.

The relations between viscoelasticity and yield stress, thixotropy need to be studied for the theoretical breakthrough.

If an applied stress or pressure drop is not sufficient to break the gel or exceed the yield stress, no flow will occur.

Comparing with the uniaxial compression, the Young's modulus and the yield stress of the biaxial compression increase obviously.

To the same material, with increasing relative density, the yield stress increased and yield region decreased.

The research will change the phenomenon that yield stress and elongation are only decided on the basis of experimental result.

and vice versa, at a high water volume fraction, the increased of yield stress is large with increased water volume fraction.

It is found that the soil yield stress of high sensitivity soil changes greatly when disturbance obeys to the function.

Xu expressed the courage of love for children, children are the yield stress, retreat.

Innovativeink gel is due to its high ink yield stress is too viscoelastic and became a cheese-like.

however, the yield stress of hours and can cause deformation in the outlets of printed matter effect.

liquidity is too small, ink yield stress is large, this is not conducive to ink transfers and business card printing and membership card.

After the heated pipeline shut down, the oils shrinkage with temperature decreasing and the yield stress emerges when cooled to some extend.

And the yield strength, modulus and post yield stress drop (PYSD) decreased with the increment of modifier content.

Shear yield stress was defined as the intercept point on the Y-axis.

The results showed: the smaller the liquid matrix of reinforcement, the greater the yield stress of soil. 5.

This paper introduced a new method of testing the static yield stress of electrorheological (ER) fluids.

The relationship between torque and yield stress, the disc radius, working gap is carried out.

In addition, the yield stress of UFG CP-Ti was distinctly enhanced compared with CG CP-Ti.

Because of the strain-rate effect, the vessel material's yield stress is increased 2. 2 times.

Studies have shown that (in the same units) the hardness of a cold-worked metal is about three times its yield stress, Y;

At a low water volume fraction, the increased of yield stress is small with increased water volume fraction;

Standard Test Method for Determination of Yield Stress and Apparent Viscosity of Used Engine Oils at Low Temperature

Standard Test Method for Determination of Yield Stress and Apparent Viscosity of Engine Oils at Low Temperature

Standard Test Method for Yield Stress of Heterogeneous Propellants by Cone Penetration Method

Some constitutive models for thixotropic fluids were reviewed, which included: (1) models without elasticity and yield stress;

The restart yield stress increases linearly with the restart pressure boosting;

Multivariate Regression Analysis of the Yield Stress of Gelled Crude Oil

The Radical Flow of Plane Fluid with the Yield Stress

A Study for Determining the Yield Stress of Lithium Lubricating Grease

Numerical Analysis on Shear Yield Stress of Magnetorheological Fluids

Hot-rolled steel sheet of high yield stress structural quality

Numeric Computation on Shear Yield Stress of Magnetorheology Fluids

Investigation on start-up yield stress of Daqing gelled crude oil

Comparison of yield stress among several plastic yield criterions

A New Method for Measuring Static Yield Stress of Crude Oil in Pipeline

Model for the Yield Stress of Magnetorheological Fluids

Experimental Study on the Static Yield Stress of ER Fluids

The Research of Yield Stress of Waxy Crude Oil

Minimum Yield Stress of Steel