working temperature

Suitable working temperature range is an important factor for obtaining optimum performance and prolonging life of batteries.

Furthermore, the resin content shall not be less than 35 % by volume, and there shall be adequate adhesiveness at working temperature.

The structural working temperature is an important factor which shall be considered in selecting steel quality.

Relevant rubber asbestos pad shall be installed between compensator and matching flange in accordance with the working temperature .

When selecting the standard flange, its working temperature of should not be lower than the designed temperature under operation mode.

Applicable scope: For fire blanket , thermal insulation interlining in high working temperature, placemat, packing sheet etc.

By applying an oxide powder on the cell coating, the density of the cell will substantially decrease, and also the working temperature.

The working temperature of the lubricating oil must be measured every hour .

The main factors to influence stability of ECLD are drift of working temperature and changes of driving current.

Measure the working temperature at any moment, oil temperature rise means the internal wear and leakage increase.

The new liquid crystals feature wide working temperature range, low voltage operation and high reliability.

The new liquid crystals feature wide working temperature range, low operation voltage and high reliability.

In this thesis an entire mathematical model for working temperature of torpedo thermal power system in steady state is built up.

In the modification, there should be a heater to provide the ink to work in its working temperature.

Flanges classification, material matching, working temperature , maximum allowabke working pressure, and structure size4.

Special burners for the lowest of outputs achieve the required working temperature.

The key of the solution is to throttle after most liquid water is separated and to drop working temperature of the separator.

It has been shown that under heat loading condition, it has a limit working temperature.

The new instrument feature wide working temperature range and high reliability.

Flanges working temperature and maximum allowable working pressure, structure size4.

Isolation type design, can DingShi reduce the working temperature of electrical components, prolong life.

Since these furnaces' working temperature is extremely high, the insulation material which can bear such temperature heat is necessary.

The higher is the working temperature, the slower is the sensitivity increasing.

Installing it at well ventilated area is priority as to maintain the working temperature of the unit.

run until the normal working temperature is reached.

Sometimes in order to make the bronzing or means of the covered work properly, you have to reduce the working temperature of the process.

Design of electrolytic capacitors: long life and wide range of working temperature.

Working temperature: after the machine run 15 minutes, when the hydraulic oil's temperature increased then be ok.

Room temperature (20-30 0C) is the optimal working temperature for the battery, extreme temperatures reduce the battery life span.

Lighsout-prower off-refrigerator not working-temperature-will rise-milk will sour.

verify the suppression of the giant magnetostrictive material working temperature rise by the water cooling system;

Finite element analysis of controlling working temperature in giant magnetostrictive actuator

The results showed the resistance to initiation fracture of PE pipe became worse with the decrease of working temperature;

Controlling the Working Temperature of the Batteries in Diesel Locomotives

Outer conductor: Soft copper wire or tinned copper wire braid shield Working temperature

Testing of the Working Temperature of Sand Cores for Aluminum Casting

Analysis on the Working Temperature of Concrete Bridges and the Causes of Crack Formation

Upper limit working temperature of resin matrix composite

Working temperature for lubricating oil

The Investigation of Relationship between Electro-photo Pulse Delay-time and Working Temperature in CuBr Laser

The maximum working temperature of heating plate

C. atomized water is supplied when working temperature is equal to or higher than the reference temperature value, ;