wall temperature

The wall temperature values from numerical calculation have acceptable agreement with that of experimental results.

The wall temperature distribution is tested on an annular combustor by using thermocouple and temperature-indicating paint.

It is significative for the design and operation of the boiler to simulate the wall-temperature of superheater well and truly.

Comparisons of the estimated and exact values show that the developed numerical mode could calculate the inner wall temperature accurately.

It also introduces the necessity of controlling wall temperature of heat pipe by means of stepwise design.

The lasing population increases as a result of the increased tube-wall temperature.

The simulation results demonstrated flow velocity, turbulence kinetic energy and wall temperature increased with increment of heat flux.

Tube wall temperature decreasing and operation consumption reducing brought remarkable benefit.

The measured results indicated that the mold wall temperature approaches the temperature of cooling water.

It is suggested to use on-line monitoring facility to measure inner furnace wall temperature, ensuring safe operation of the boiler.

Wall temperature is measured by thermocouples, instrument displays temperature, and data is collected by data card.

Oscillate phenomena of local wall temperature is found in the experiment, and is analyzed on the effect of heat flux and mass flow rate.

In addition, the wall temperature in the adiabatic section fluctuates regularly and periodically under the steady working conditions.

At the same oil and wall temperature, the wax deposition rate increases with increase of flow velocity.

Stainless steel single and double wall temperature control containers .

It is found, from analysis of experimental result, that thruster performance declines along with wall temperature arise.

In the end, a correction formula to get real wall temperature is built through simplifying the radiation transfer equation.

The optimal coefficient of excess air was related to the mass flow rate of methane and wall temperature.

The rule of wall temperature distributions differs for different walls.

There is an optimal inlet concentration, which corresponds to the lowest wall temperature and the highest hydrogen fraction at the outlet.

It is very important for improving boiler's efficiency and safety to monitor on wall temperature of heat exchanger in boiler.

It is very important for selection of material and working procedure to predict wall temperature of flue gas line.

By use of implicit scheme, exit and wall temperature varying with time in air- precooled heat exchanger for compound engine are extracted.

Numerical Analysis of Factors Having an Impact on the Wall Temperature of a Membrane Water-wall

Experimental Investigation on Outer Wall Temperature Distribution of a Pulse Detonation Engine Model

Experimental Research about the Wall Temperature Distribution on the Oscillating Heat Pipe Fixed up as a Plate

Reconstruction Measures by Decreasing Wall Temperature in Reforming Chamber of Light Oil Gas Manufacturing Furnace

Influence of Wall Properties on Wall Temperature of a Radial Flow MOCVD Reactor with Three Separate Vertical Inlets

High Temperature Convective Superheater Tube Wall Temperature Calculation and Analysis under Different Air Distribution Modes

Calibration Method for Calculating Tube Wall Temperature of The High Temperature Convective Heat Transfer Surface in The Utility Boilers

Effective ways to lower down the wall temperature of reforming chamber

Effect of the Positions of Thermocouples on the Wall Temperature Measurement

Computation of Wall Temperature in Back Platen Superheater and Its Comprehensive Life Evaluation

Computation of Wall Temperature of a Combustor's Maze Composite Cooling Structure

Analysing Superheater Safety and Developed Software Calculating Tube Wall Temperature for Industrial Boilers

Approximate Solution of Expanded Boundary Layer Equations of Forced Convection Airflow Along a Flat Plate with Changeable Wall Temperature

Test and Calculation of the Tube Wall Temperature of a High-temperature Superheater

Research on the circumferential distribution of wall temperature for horizontal evaporating tubes under annular flow

pulverized coal flat burner; wall temperature; mathematical model; burn out; operating reliability;

Quasi-three Dimensional Calculation of Missile Wall Temperature and Infrared Radiation of the Missile

Design and Operation of Superheat Temperature Control System Concerning Superheat Wall Temperature

Solution to wall temperature and indoor temperature in CFD simulation of thermal environment in a large space building

Laminar heat transfer of gas in extremely narrow parallel plates with one wall temperature constant and the other adiabatic

The Application of Integrated Modular Modeling Software for Tube Wall Temperature Online Monitoring System in Boiler of Power Plant

Temperature Field Destroy Analysis of Notch- lay- thermocouple Method for Measuring Round Pipe Wall Temperature

Calculation of Wall Temperature Differential Stresses for Single Pass Fixed Tube- sheet Heat Exchanger

Research into heat transfer of ice-slurry in a circular tube with constant wall-temperature

Problems in monitoring steam and wall temperature of large utility boilers and suggestions for improvement

A Numerical Simulation on the Influence of Pulsating Flow on Convective Heat Transfer at Constant Wall Temperature

Prediction of wall temperature deviations for manned space capsule on ground thermal equilibrium test

Experimental Investigation and Theoretical Analysis of Membrane Water Wall Temperature in a 600 MW Boiler Unit

Numerical Calculation of The Three-Dimensional Wall Temperature of The Combustion Chamber Using Heat - flow Coupling Method

Research on the water wall temperature excursion in the supercritical and ultra supercritical boilers

The Control for the Drum-Wall Temperature Differences of Natural Circulating Boilers

An Online Wall Temperature Monitoring System for High Temperature Heat Delivery Surfaces of Boilers

The Reason of Bricks Mixture Structure Wall Temperature Crack Appearing and Prevention and Cure Measure

Constructing methods of brick-concrete outdoor wall temperature-keeping

Study on Wall Temperature Characteristics of Swirling Burner in Pulverized-fuel Boiler

The experimental study of wall temperature in entrained-flow gasifier based on BP neural network

Experimental Study on In-wall Temperature Measurement of the Closed-bomb

Control and prevention of boiler steam drum wall temperature difference in power station

Application of Low Temperature Reheater for Spiral-ribbed Tube and Study on Wall Temperature

Soft-sensing on In-wall Temperature during Millisecond Range Heat Transfer in Closed-chamber

Study on calculation of new type energy saving wall temperature under cold load

The analysis of failure examples of expansion joins in FCCU unit and effect of wall temperature on their working life

Investigation of Metal Wall Temperature of Boiler Over-Heater and Pipe-Bursting

Evaluation index of wall temperature response under the convective boundary condition

Analysis of Cause Produced by Wall Temperature-difference Crack of Top Roof of Building

The Measure of Preventing a Air Heater Tube Wall Temperature from Superheating

Studies of the Start-up Parameters on Wall Temperature of Reheater

Modular Design and Application of Tube Wall Temperature Online Monitoring System of Boiler

Method for Mesh Generation in Numerical Simulation of In-wall Temperature

Numerical Simulation of Heat Finned Pipe Air Preheaters with Variational Wall Temperature

Influence of heat pipe structure on the lowest wall temperature of air preheater

Study on Near Wall Temperature Variation of Heated Jet in Crossflow