stick slip

Wheel squeal is associated with a complex combination of creepage and a mechanism known as stick-slip.

The abrupt disappearance of stick-slip at the lower speed level is attributed to changes in the elastic deformation of the fiber.

The results showed that the criterion can correctly predict whether stick-slip will occur directly from working parameters.

The torque feedback system is a successful technology for eliminating stick-slip vibration of drill-string assembly.

Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.

The system steady-state error and the stick-slip phenomenon caused by the nonlinear friction are analyzed.

The friction between gabbro and marble exhibited stick-slip with visible displacement weakening.

there is no stick-slip effect of rolling contact bearings, starting torque is small, run a small friction.

This same stick-slip mechanism has been strongly implicated in the formation of short-pitch corrugation and associated roaring noise.

It will also provide additional diagnostics on stick slip, shaft integrity, and maximum and minimum torque.

The results show that Huangcaoba faults latest activities for the holocene early, and fault was dominated by stick slip.

Once the force generating the creepage is spent by the sliding 'action, the stick-slip process begins again (Figure 1).

The goal of the study is to develop a system to measure temperature change in the operation of the stick-slip actuator.

to ensure continuous and stick-slip free operation.

The friction plays an active role in the stick-slip actuator.

Sun Waylubes 1180 and 1190 can improve machining precision due to elimination of stick-slip and chatter of slideways .

In order to eliminate the stick-slip phenomenon, a linearization of the nonlinear model is made at the middle point of the cylinder.

For limestone no stick-slip was observed.

the stress drop and axial displacement in stick slip were much less than that in the eventual fracture.

Macroscopic and Microscopic Evidence of Periodical Stick-Slip Deformation in an Active Fault

Modeling of a Stick-slip Friction Pair and its Application on the Dyanmics of Railway Vehicles

Numeric Simulation on Destructive Effect of Golmud- Lhasa Railway Resulting in Stick-Slip Movement of the Eastern Kunlun Fault

Mechanism Analysis on Torsional Stick-slip Vibration of Drillstring in Extended Reach Well and Some Ways to Its Suppression

Study on Hydraulic Limps Depart Stability in the Stick-slip Friction Effects on the Hydraulic Elevator Actuator

Control of Stick-slip Phenomenon on Silicon Interface under Relative Humidity Conditions

Analysis on stick-slip resulted in hydraulic system of machine tool and its elimination

Simulation Analysis of Stiffness and Dampness Ratio for the Stick-slip of Machine Tool

Stick-Slip Criterion of Unsymmetrical Cylinders Driven by Meter-Out Circuit

Modeling of the Motion and the Estimation of Stick-slip in Pneumatic Cylinders

Present research situation and analysis on machine tool stick-slip motion

The Simulation and Active Control Measure of Stick - slip Motion of Machine Tool

A Solution of Stick- Slip Motion and Hysteresis for Pneumatic Control Valves

Modelling and Simulation of Stick-slip Motion in Pneumatic Cylinder

Nonlinear Stick-slip Friction Compensation for DC Motors

Motion Model and Vibration Equation of Machine Tool Feed System in Stick-slip

Study on Criterion about Overcoming Low-Speed Stick-Slip of Simulator

Dynamic Analysis of Miniature Piezoactuator Using Stick-Slip Friction Model

Optimal control of low speed stick-slip motion of hydraulic servo system

Research on Measurement System of Stick-slip Signal in Machine-Tool

Stick-slip Criterion of Cylinder Based on Experiment and Dimensional Analysis

Control of Micro Stick-Slip and Stiction in MEMS

Experiment on Stick-Slip in Low-Speed for NC System

Stick-slip Control of AC Servo Worktable Based on Friction Compensation

Study on rock burst using stick slip model