subnet mask

A matching network for the specified IP address could not be found. Please also specify a subnet mask and a cluster network .

The dedicated subnet mask is not valid. A subnet mask must be contiguous. Enter a valid subnet mask.

If a host does not know the subnet mask, it may send an address mask request to the local router.

The subnet mask for the specified IP address cannot be automatically detected . You must identify it manually .

Make sure that all computers within the same subnet have the same subnet mask and network portion of the IP address.

Type the IP address for management of the cluster. The subnet mask may be supplied automatically.

The Cisco Catalyst Network Switch automatically fills in the subnet mask at the end of the IP address.

The subnet mask helps your computer define the difference between the two addresses.

Other than entering IP Address, MAC Address and Port, you need to enter subnet mask as well.

The subnet mask could not be supplied automatically for this IP address. Please check the address to make sure it is correct.

Configure DHCP service for each network server can provide an IP address, subnet mask, default gateway, and DNS server address.

The zero at the end of the subnet mask represents a unique host within that network.

The ICMP address mask request (and reply) is intended for diskless systems to obtain its subnet mask at bootstrap time.

The host subnet mask is incompatible to the subnet mask of the attached router interface.

Including: communication subnet mask, user resources.

You entered an invalid subnet mask. The subnet mask has to be contiguous. Please enter a valid mask.

Enter the subnet mask for the IP address and select the network in which the IP address will answer.

The subnet mask entered for the IP address is not valid. Enter a valid subnet mask.

The Dynamic Host Configuration Protocol (or DHCP) can be used to identify network parameters such as IP address and subnet mask.

All of the bits in the host address portion of the IP address are set to 0. Please enter a valid combination of IP address and subnet mask.

The dedicated IP address and subnet mask are not valid. Enter a new dedicated IP address and subnet mask.

Subnet mask is used to identify the network class in an IP address.

The destination address has been adjusted by the specified subnet mask.

Invalid IP address and subnet mask for the management network.

The subnet mask is not valid. Enter a contiguous subnet mask.

You cannot create a single scope that contains the IP address range and subnet mask you specified.

The cluster IP address and subnet mask are not valid. Type a new IP address and subnet mask.

This address mask reply will identify the correct subnet mask.

the network address, the broadcast address, and the subnet mask.

The combination of IP address and subnet mask is invalid.

The client should use ICMP for subnet mask discovery.

Is not a valid dedicated subnet mask entry. Please specify a value between %2 and %3.

You have entered an incomplete or blank Subnet mask. You need to complete the Subnet mask or choose to obtain an IP address automatically.

is done according to subnet mask, not the masks here.

Is not a valid subnet mask entry. Please specify a value between %2 and %3.

Each host in a LAN has a subnet mask.

You entered an address that is missing its subnet mask. Please add a subnet mask.

You must provide a subnet mask.

Study on Classless Inter- Domain Routing and Variable Length Subnet Mask Technology

Application of the Subnet Mask and the Variable Length Subnet Mask

On subnet mask of network administration and scheming

Subnet Mask And Its Application

Subnet mask in use for the local numbered interface

Classification of IP Address in Subnet Mask

Design Method for Subnet and Subnet Mask

To add an IP address and subnet mask by using CIDR, run the following command

Match the IP address based on this subnet mask: , s

Subnet mask in network byte order

IP address and Subnet Mask

Netmask (also known as subnet mask): 255. 255. 255. 0