shadow copy

Each assembly was checked to see whether it had been updated more recently than the copy in the shadow copy directory.

The command does not allow any backups ( Volume Shadow Copy Service or legacy streaming backups ) to be running on the same storage group .

LCR also enables you to offload Volume Shadow Copy Service ( VSS ) backups from the active storage group to the passive storage group .

It provides a continuous reorganization of a table without the excess disk space associated with the traditional "shadow" copy approach.

If a shadow copy of your document exists, it may be possible to recover a recent version of the document.

If an executable file is in use, updates to the executable file are stored in a shadow copy directory.

The Cluster service also registers itself at startup as a backup writer with Volume Shadow Copy service .

These methods include using Automated System Recovery (ASR), restoring from a shadow copy, and restoring from a drive image.

Gets an indication whether the application domain is configured to shadow copy files.

After receiving a backup request, Volume Shadow Copy service notifies Exchange services that a backup is about to occur.

Cannot create a shadow copy because another shadow copy creation is in progress.

Use an Active Directory-aware backup and restoration utility that uses Microsoft Volume Shadow Copy Service APIs.

Exchange then uses the shadow copy (rather than the working disk) to create the actual backup, therefore normal operation can continue.

Many users employ a shadow copy of their database ( Figure 4) to support large and ad-hoc queries against the operational data.

In particular, the new Volume Shadow Copy service may challenge the limits that your SLAs previously imposed.

The shadow copy of volume %2 could not create a new paged heap. The system may be low on virtual memory.

True to load a shadow copy of an assembly into the application domain.

Then I used my vaunted writing skills to pen a short and sweet "Shadow Copy Advisory" memo and emailed it to every user.

If you use Volume Shadow Copy Service (VSS), you need a third-party Exchange and VSS-aware backup application.

New database of remote shadow copies was created by the Volume Shadow Copy Service.

But this approach poses scheduling problems and negates any benefit of shadow copy backups.

We need skills in the area of VSS (Volume Shadow Copy Service), Registry keys and values for backup and restore.

Volume Shadow Copy service, however, creates a consistent point-in-time shadow copy of data while the system is online.

Windows XP introduced a technology called Volume Shadow Copy to make point-in-time snapshots of disk volumes.

The shadow copy of volume %2 could not be created due to insufficient resources for worker threads.

For more information, visit the following Microsoft Web site and search for "Volume Shadow Copy Service"

The Volume Shadow Copy Service (VSS) was created to make consistent point-in-time copies of data.

The shadow copy of volume %2 became low on diff area space before it was properly installed.

If so, it was copied to the shadow copy directory.

Preparing to backup using shadow copy. . .

The shadow copy files of the cluster registry.

The association between a shadow copy and the volume for which the shadow copy was created.

otherwise, the copy in the shadow copy directory is loaded.

Configure shadow-copy backup of volumes.

The changes are then applied later to the shadow copy.

Before a client computer can access shadow copies, you must install the Shadow Copy Client.

No shadow copies present in the given shadow copy set.

Then remove the old shadow copy storage association by using the VSSAdmin command Delete Shadows.

To use the new shadow copy APIs to back up databases, you must use a third-party solution.

The shadow copy of volume %2 was aborted because of a failed free space computation.

Then remove the old shadow copy storage association by using the VSSAdmin command Delete ShadowStorage.

The shadow copy of volume %2 took too long to install.

The shadow copy of volume %2 was aborted because of an IO failure.

The shadow copy of volume %2 could not create a diff area file on volume %3.

The shadow copy of volume %2 was aborted because of insufficient paged heap.

The shadow copy of volume %2 is aborted because of insufficient memory pool.

Shadow Copy Restore is a component of the intelligent file storage technologies in Microsoft Windows Server 2003.

The Volume Shadow Copy service for Exchange is disabled in Microsoft Windows Small Business Server 2003.

Exchange also supports Volume Shadow Copy service for Windows Server 2003.

Exchange 2007 supports hardware-based snapshots using the Volume Shadow Copy Service (VSS) implemented in Microsoft Windows Server 2003.

The backup process may fail and a time-out error may occur in Volume Shadow Copy Service writers

The operating systems that require the Shadow Copy Client include

An animated demonstration of Volume Shadow Copy Service

To optimize storage for Volume Shadow Copy service performance, you should

Support for Volume Shadow Copy service

Introduction to Shadow Copy Restore

Paused for Volume Shadow Copy

A new Volume Shadow Copy Service update is now available that fixes various Volume Shadow Copy Service problems in Windows Server 2003

An update is available to optimize the way that the Shadow Copy Client accesses shadow copies in Windows Server 2003 and in Windows XP,

Download details: Shadow Copy Client: Accessing Shadow Copies on Windows Server 2003

Shadow Copy Client: Accessing Shadow Copies on Windows Server 2003 also downloaded

Event ID 21 is logged when you create a shadow copy backup on a Windows Server 2003-based computer