rotation speed

Therefore, it can think of that rotation speed has no effect on leakage and torque in the calculation.

The correlation between the cutting width limit and the rotation speed of the spindle in a regenerative chatter system was derived.

Note: dribble turns, slower start, to be gradually increased after skilled rotation speed, frequency and time limited.

Rotation speed has great effects on the flow of plastic material. With the rotation speed increases, the size of TMAZ also increases.

and as the double-cylinder form greatly reduces the rotation speed of the compressor, the noise of mechanical vibration is greatly reduced.

The rotation speed can be changed according to the practical needs to meet the best separation effect.

The results showed that lignin, compatibility, plasticizer, rotation speed and temperature all had obvious effects on the torque.

Test results indicated that the ceramic throwing machine with rotation speed thus adjusted had good performance.

The rotation speed of turntable is adjusted by VVVF facility through a knob in electric panel.

The results show that oil filling ratio is decreased and wall heat transfer coefficient is increased as increasing engine rotation speed.

The testing data of water turbine runner obtained from varying rotation speed experiment of the hydro-generator unit is analyzed.

The effect of rotation speed and load on the lubrication life of bearing working in vacuum was investigated.

Launch site latitude lower east fired rockets available Additional Earth rotation speed to satellite orbited.

For robot's forward speed and self-rotation speed to use expert PID control, realized soccer robot's trajectory tracking.

This separable bearing can support axial load with low limit rotation speed, and has single and double direction two kinds.

Amplified by proximity, the gravity of the stars modifies the rotation speed of the ellipses .

The higher the rotation speed of the turnplate and the degree of superheat, the more finer the particle size.

Special lateral cross-flow fan makes lower fan rotation speed, which ensures lower noise and vibration levels.

A pulse width modulation(PWM) DC motor rotation speed control experiment system device is developed.

You can base this prediction function on the speed of the object, steering or rotation speed.

This paper presents a state space model based on spindle rotation speed for thermal errors of machine tool.

Electronic speed controller to achieve optional rotation speed.

also can control the pulse frequency to control motor rotation speed and acceleration, so as to achieve speed control purposes.

Before the formal gelatinize also gelatinize sector rotation speed adjustment and locking.

The first integer on an input line is the wheel's rotation speed.

When the pressure of jet is high enough, the efficiency of breaking rock will be increased if rotation speed improves.

when the temperature is higher than 28deg. C, the compressor uses high rotation speed, the crisis spanning capillary is connected.

Current wheel axle rotation speed, in rotations per minute (Read Only).

The ECU (20) calculates a rotation speed of a crankshaft (17) in a predetermined period based on the sensor signal.

A new method for measuring transient rotation speed and torque for motor has been presented in this paper.

cylinder speed size on the selected don't index also has effect on low rotation speed and low yield.

VB written procedures for image rotation speed can also welcome to use.

A type bowl rotation speed is variable.

VR (ROTATION SPEED), The speed at which aircraft rotation begins in order to achieve a speed of V2 at 35 feet above the runway.

The fan rotation speed controlling system controls fan based on one reference clock.

The Application of Spectrum Analysis in the Measurement of Rotation Speed of a Hermetic Refrigeration Compressor

Design of Antenna Pedestal with High Rotation Speed and Lightweight for a Shipborne Surveillance Radar

Study of Pipe Network Vibration for High Rotation Speed Reciprocating Compressor

In order to study this method and to measure the error, a six-levels rotation speed test has been designed and carried out.

A simulation calculation of rotation speed and pressure drawdown of micro-hydraulic turbine in a heat exchanger tube

the automatic regulation of rotation speed is achieved by converter technique controlling the frequency of frequency speed regulator;

Application of a High Precision Laser Sensor in Rotation Speed Measurement of Turbochargers

Drilling Parameter Model with the "Low Rotation Speed - High WOB" of PDC Bits and Its Application

Electric Control for Realizing the Positioning of Milling Cutter Axle and Its Rotation Speed

A Method for Filtering out Distorted Points from the Crankshaft Instantaneous Rotation Speed Signal of Engines

Analysis of Mechanical Characteristics of Ballistic Spring Under High Rotation Speed

Vibration Analysis of Frame Foundation of High Rotation Speed Centrifugal Compressor

Method of improving the measurement accuracy of photoelectric infrared rotation speed sensor

On Measurement of Motor Rotation Speed and Design of Monitoring and Warning System in a Lab

Experimental Research of Suction Seed Metering Device about Pressure and Rotation Speed

Study on Variation of Performance Coefficient of Gas Engine Heat Pump with Compressor Rotation Speed

Selection of Rotation Speed for the Pump Turbines in the Pump Storage Power Station in Huizhou City

Research on Rotation Speed Measurement Technology of Engine Analyzer

Calculation of effect of dynamic property of oil film on critical rotation speed of rotor in journal bearings

Study of the Feasibility of Time Fuze Based on the Rotation Speed Sensor

Study of Mixer Rational Rotation Speed

The Rehcnical Reformation of The Rotation Speed Standard Installation

Influence of Rotor System Parameters on Critical Rotation Speed for Rubbing

A State Equation Model Based on Spindle Rotation Speed for Thermal Errors of Machine Tool

The Effect of the Rotation Speed of Drum Magnetic Separator on Magnetic Separation Result

Cause Analysis on Rotation Speed Fluctuation of DC Variable Speed Machine

An Analysis on the Starting Process of Diesel Engine with Instantaneous Rotation Speed

The measurement method and the error analysis of the motor's rotation speed

Causes and Treatment of Fluctuation Rotation Speed of Steam Turbine

Design of Generator Rotation Speed Signal Measuring Equipment Based on Programmable Logic Controller

Measurement of rotation speed of high-speed rotating-mirror camera

Effect of Initial Crank Angle on Rotation Speed of Revolving Gun with Inner Energy Source

Analysis of Rotation Speed Ripple for Permanent Magnet AC Servo System

Control of DC motor rotation speed using microcomputer timer

Not homogeneous melt (Back pressure is too low, rotation speed is too fast)

Vibration Measurement and Analyses of Ultracritical Rotation Speed Autogenous Mill Based on Virtual Instrument Technology

An Approach of Active Steering of Independently Rotating Wheelsets Based on Feedback of Wheels Rotation Speed

The Phase-different Detection Method of the Signal of JCZ Torque and Rotation-speed Sensor

Control Method for Adjuster of Rotation Speed Based on Optimization Theory of Second Order

Calculation of rotation speed of roll for tension sinking mill

Estimation of Rotation Speed for Induction Motor under Non-sinusoidal Power Supply Based on Modified BP Network

Kinetic emulation of blade in variable rotation speed

Rotation speed control of marine diesel engine generator based on artificial neural network

Grinding Kinetics of Ultracritical Rotation Speed Mill

The System of Motor Rotation Speed Real Time Monitor and Measurement Based on PLC

An Active Noise Control Strategy and Adaptive Algorithm in Vehicle Based on Engine Rotation Speed

Analysis on Breaking Dynamics Based on Rotation Speed of Classification Crusher

drive the spindle motor according to a perturbing torque to change the rotation speed of the spindle motor;

The annual variation of the earth's rotation speed

High precision of rotation speed measuring based on photo- electricity coder

A New Kind of Method for Measuring Rotation Speed

Digital Detecting of Motor's Rotation Speed

How to use the monolithic machine to inspect rotation speed and angular displacement

An AC rewinder constant tension open loop control plan based on rotation speed control

Design of Direct Adaptive Fuzzy Controller Based on Rotation Speed for Gas Turbine

The Measuring Method of Rotation Speed Based on Single-chip Microcomputer

The Development of A New Revolving-wing Rotation Speed Meter

Design of rotation speed sensor for automotive wheel based on CAN bus

Rotation Speed of Main Saw Blade

A novel method measuring rotation speed based on linear CCD

The Design of Measuring Rotation Speed System Based on PLC

Measurement method of torsion and rotation-speed based on JCZ sensor