reference voltage

The peripheral voltage of the system is divided through a fourth resistor and a fifth resistor to obtain a reference voltage.

The second voltage and the reference voltage are respectively inputted to a negative pole and a positive pole of a first comparator.

The third voltage and the reference voltage are respectively inputted to a positive pole and a negative pole of a second comparator.

The reference voltage, VREF, is applied externally and can be set up to the supply voltage, VDD.

While it is charging, a voltage comparator constantly compares the voltage across the capacitor to a reference voltage.

"Ground reference" is no longer a simple choice, as one reference voltage may work for some DEVICEs, but not others.

The peak load current limit is set by the user's selection of a reference voltage and current-sensing resistors.

The built-in DAC acts like a switch by switching the integrator input to a positive or a negative reference voltage.

The reference voltage, REF, is applied externally and can be set independent of the supply voltage, VDD.

This example, the output code is sensitive to relative changes between the bridge excitation and reference voltage.

MOA; valve piece; resistive current; infrared detection; frequency reference voltage.

and the selecting unit selects first voltage or second voltage according to the output data to be used as the reference voltage.

and controlling the pixel capacity voltage of the liquid crystal panel according to the Gamma reference voltage parameter.

For high resolution ADC, the accuracy of reference voltage is critical for the whole design.

The reference voltage generation unit provides a plurality of voltage levels.

A reference voltage generating portion 6 receives an output voltage of resonance circuit 1 for outputting a prescribed reference voltage.

Resistors require a reference voltage to work.

Advanced users make use of the Analog Reference (AREF) pin to provide a reference voltage.

The regulating process of S3R is analyzed, and the method of calculating the reference voltage of hysteretic comparator is given.

The reference voltage supplied to the AD7760 determines the analog input range.

The reference voltage supplied to the AD7764 determines the input range.

The first stage circuit receiving the first reference voltage input, while the second input to receive input signals.

Conclusion: We're usually not talking about earth, or safety ground, when we need to specify a reference voltage.

A kind of reference voltage generation circuit is presented also.

Dead-time is compensated according to the output reference voltage vector and phase currents.

A semiconductor integrated circuit includes: a main-interconnect to which supply voltage or reference voltage is applied;

Design of a Low Temperature Fluctuation Changeable Output Bandgap Reference Voltage

acquiring the backlight dimming coefficient and the Gamma reference voltage parameter of the same frame of an image;

Design of High-Speed Programmable Reference Voltage Discriminator Used in Photon Counting

the stable time of reference voltage is less than 7 seconds;

An Adaptive Harmonic Current Calculation Arithmetic for APF Using PLL-Produced Reference Voltage

A High Performance Differential Reference Voltage Generator Used in ADC

Design of Piecewise Compensation CMOS Bandgap Reference Voltage Source

Novel Reference Voltage Generator with High PSRR and High Temperature Stability

A New Algorithm for the Zone Decision of Reference Voltage Vector of Three-level Inverter

Ratio of Change in Reference Voltage to the Change in Cathode Voltage

Programme Design of Reference Voltage Source Module Embedded in LCOS Chip

A Bipolar Energy Gap Reference Voltage with Low Voltage and Temperature Draft

Design of Changing Reference Voltage