pressure loss

After analysis, the structure can be improved and optimized to be a less pressure-loss and a shorter response-time.

The tradeoff comes in how much permanent pressure loss can be tolerated.

The results show that the total pressure loss coefficient decreased gradually with the slot position closer to the blade trailing edge.

Deep and ultra-deep well pressure loss calculation is a new issue to be resolved during the deep oil and gas exploration and development.

Based on this, the total pressure loss coefficient and the change of pressure coefficient of the cascade are also given.

After that, we figure out a ladder-type wind tunnel to bring out uniform suction, and provide several means to reduce the pressure loss.

If oil pressure was low and pump is within specifications, inspect for worn engine bearings or other reasons for oil pressure loss.

Only approved and low-pressure loss shaped parts shall be used for bypasses and branches.

No moving parts inside measuring pipe, easy maintenance and management. Unimpeded flow of parts, less pressure loss.

Half ellipse head and tine end of the turning vane cause the lower pressure loss and aerodynamic noise than the hemicycle end.

New cars are also equipped with tyre pressure monitoring devices which warn the driver of a tyre pressure loss.

With the increase of porosity of ceramic honeycomb, pressure loss decrease obviously, but regenerative capacity decreased obviously.

The research results show that pressure loss is an important factor of heating in a hydraulic system.

Two fluid model was used to calculate the frictional pressure loss for stratified flow pattern.

Pressure loss is minimized thanks to the short distance between the hydraulic accumulators and the hydraulic block.

Due to their restricted possibility for cleaning and the increased pressure loss, flexible air pipelines shall be minimized.

Fume hood shall be designed to minimize static pressure loss. Bell shaped exhaust collar configuration shall be provided.

The method results in a lower pressure loss in the scrubber system, while retaining the same separation efficiency.

Acoustics. Measurement procedures for ducted silencers. Insertion loss, flow noise and total pressure loss.

Under production with constant pressure, the pressure loss in the wellbore has obvious effect on the production rate at the initial period.

The result demonstrates that the fiber with large concentration increases the turbulence dissipation and the pressure loss.

With the increase of coal mine methane superficie velocity, pressure loss and outlet temperature of the oxidation bed increase.

Chemical control of iron transport, oxide deposition and pressure loss in helical once-through steam generators.

Therefore, the main means to increase gas flow is to reduce roughness of gas pipeline so as to reduce the pressure loss.

These include: oil tank stress, scheduling stress oil tank, piping system pressure drop ( pressure loss).

Experimental datas show that using stepped pipe can reduce effectively air flow speed, pressure loss and energy loss.

cereals , oilseeds and pulses . measurement of unit pressure loss in one - dimensional air flow through bulk grain.

More accurate calculation of pressure loss in narrow annuli of slim holes and coiled tubing operations is required.

At a lower flight Ma, there is higher combustion efficiency as well as larger total pressure loss.

The study involves the distribution of total pressure loss factor, outlet gas flow static pressure and Mach number along the blade height.

no movement and protruding parts in the tube and little additional pressure loss in measurement.

With the help of simulation results, the reason of pressure loss was discussed briefly.

Part of enterprise profit, even in business status in the break-even, There is a minority enterprise is under pressure loss.

The results show that: the pressure loss of muffler elements increased dramatically with the inlet velocity increased.

With the increase of equivalent diameter, pressure loss decrease significantly. 3.

Gas supply network small, internal leakage less pressure loss.

The methane concentration has less effect on pressure loss.

The longer the expand length is, the smaller the inlet diameter is, the greater the pressure loss of expand muffler element is.

The frictional pressure loss of oil-water two-phase flow were also studied experimentally and theoretically.

At the same time the pressure loss during the pellet discharge is reduced.

Type 0- Full round port opening offering minimum pressure loss conditions.

one-way valves in order to require the reverse pressure loss and pressure loss values should be less positive.

At high temperature, the resistance loss of the three-way catalytic converter is mainly caused by the pressure loss of substrate.

The pressure loss of the substrate located in the middle pipe is bigger than that in the top and bottom.

It can not require a pressure loss .

The results show that the total pressure loss increases with the increase of incidence, provided that the incidence is positive;

acceptable pressure loss across the heat meter;

Troubleshooting of Pressure Loss Failure in Hydraulic System for a New Type Construction Machine

Experimental Study of Carbon Black Pressure Loss in Pneumatic Conveying

absorption cross section acceleration pressure drop acceleration pressure loss

Permanent Pressure Loss Comparison among Various Flowmeter Technologies

Combustor pressure loss [ or stagnation pressure recovery coefficient of combustor is adopted];

Inspecting defects inside impeller of electric submersible pump by fluid pressure loss measurement method

the increase of channel flow length results in the increase of both discharge coefficient and relative pressure loss;

Research on influencing factors of fire hose's pressure loss and its calculation method

the increase of equivalent diameter ratio results in the increase of discharge coefficient and the decrease of relative pressure loss;

A General Model for Calculating the Influence of Steam Extraction Pressure Loss on a Unit's Thermal Efficiency

Accurate Hydraulic Model of Predicting Downhole Circulating Pressure Loss

Research on the pressure loss characteristics of variable-angle pipes for pneumatic conveying

Pressure loss constitution and causative factor analysis to the preheater system

Calculation and Analysis of the Pressure Loss in Narrow Annular in Slim Hole Drilling

Influence of Rib's Geometric Parameters upon Heat Transfer and Total Pressure Loss in Grid-Ribbed Channel

Pressure loss or updip of barrows during tension stringing: analysis and precautions

Study on pressure loss characteristics of internal bypass flow path for marine steam turbine

Pressure Loss in Pipe for Conveying Waste Plastic Particles Injected Into Blast Furnace

A Novel Model of Calculating Circulating Frictional Pressure Loss in Narrow Annuli

Experimental Research on the Pressure Loss Performance of Metal Fibre Burner

Strength of body and hydraulic pressure loss testing of backflow special check valves

Pressure Loss in Solid-liquid Flow with Coarse Manganese Nodules in Vertical Pipeline

The research of total-heat-transfer coefficient and pressure loss in plate coil exchange

Calculation of pressure loss in hydraulic transmission

Patented torsion spring check provides lowest pressure loss

Pressure Loss Research of Perforated and Non- perforated Muffler

Study on the Influence of Extraction Steam Pressure Loss on Thermal Economy of Unit

Methods for Reducing Pressure Loss in Hydraulic Driving System

Experimental study of the pressure loss of hoses of hard hose traveler

The Effects of Monolith on the Flow Field and Pressure Loss in Catalytic Converter

Analysis and Calculation on Pressure Loss in Hydraulic System

A Method for Computing the Circulating Pressure Loss in Slim Hole Annulus

Pressure loss for accelerating material

Calculation of circulating pressure loss in annular of slim hole

Transformation and Type Selection of Throttling Devices According to Pressure Loss

Study on Pressure Loss in the Pipe of Pneumatic Conveying of Waste Plastics

Reason Analyses on Pumping Pressure Loss of a Concrete Conveyer Pump

Measurement and analysis on Pressure-Loss and Air-Leakage in Waste Gas Treating System of BOF

Numerical Simulation on Flow Pressure Loss and Heat Transfer in U-tube

Patented tri-link check provides lowest pressure loss

large capacity , small system pressure loss

Calculation of local pressure loss in steam heating pipes

Less Pressure Loss ? Streamlined Melt Flow

Streamlined Melt Flow ? Less Pressure Loss

A Study on the Effect of Pressure Loss in Three-way Catalytic Converter on Engine Performance

Study on water passage ability and pressure loss of filtration membrane for suspended particulate matter in deep sea

The calculate on pressure loss in drilling with foam

The Effect of the Pressure Loss in Wind Chamber on the Flow in Injector

pressure loss in steering control valve

Pressure loss for lifting material

Second Minute Hour Converting Pressure Loss Over Time To Flow

Exact Mathematics Model of Extraction Steam Pressure Loss of heater for Absorbed Heat in Re-heater

Experimental Study on Total Pressure Loss of Special Evaporating V-Gutter Flame-holder

Study on Lowest Wind Speed and Pressure Loss of Drilling Dust Extraction with Wind-force for Borehole

Design and Calculations of the Pressure Loss of Venturi Scrubbers

Dimensional Analysis Application in the Study of Main Pressure Loss of Circulating Fluidized Bed

Short air inlet hose, less pressure loss

CFD Computation of Pressure Loss of Single and Dual-Chamber Resistance Mufflers

Coupling Design of Gas-water Cooler Based on Heat Transfer and Pressure Loss

Fire hoses; pressure loss test

Pressure loss in drilling rod

total pressure loss for gas side

Investigation on Flowrate and Total Pressure Loss of Flow Through Steam-Turbine Control Valve

Pressure loss of dust collector

Pressure loss of manifold trunk