pore size

They are also easy to fabricate and can BE produced with a wide range of pore size cutoffs for ultrafiltration.

On this basis, the gradient of pore size distribution can be made of the excellent performance of ceramic membrane materials.

A strong, high density foam glass tile having a small pore size which can be used as a facade on both exterior and interior building walls.

Like this, oxidation film of homogeneous pore size and good compactness can be obtained.

Pore size controlling technology is an effective method for mesoporous molecular sieve to be the advanced material.

The effects of the size change of the quadratic grain on the pore-size distribution and other relative problems are also be researched.

The characterization results of the catalyst show that the PAS molecular sieve has more pore-size distributions for VGO isomeric. . .

The results indicate that the porosity and the pore size can be controlled by the spacer materials volume and size.

The pore size and the length of the pore channel may be controlled by using the desired foam structure and size.

Dot rate depends on the paper size, paper surface properties, as well as the pore size.

The result indicated that the ability of new crystal formation was different from pore size of porous calcium phosphate ceramics.

At the time by narrow pore size comes to take a certain amount of charge so that the control comes from the impact point.

Cotton supply various headphones, squint cotton, cotton microphone The ventilation products, Rally strong, uniform pore size.

Foams were produced by mechanical stirring after adding surfactant into the ceramic slurry, and pore size and shape were. . .

The greatest impact of materials, pore size followed by, the sample size is the smallest.

The specific surface declines with the increase of pore size, which results in the improvement of infiltration coefficient.

V. value was lower than 11%. The size of chitosan microspheres could be controlled by using membranes with different pore size.

After addition of citric acid, the large pore fraction in hardened gypsum paste was increased and the pore size distribution was coarsened.

Patterns of pore size-pore volume distributions of activated carbons from different sources are summarized.

Results showed that the influence from lignin amount is obviously on the pore size and other basic properties for prepared carbon membrane.

The BET results showed that the catalyst has mesoporous structure and large pore size distribution.

The change laws of pore size, water flux and retentivity of the membrane with pres-sure are investigated.

The more smaller pore size, the more stronger internal Magnetic field gradient. The nmr porosity is significantly lower.

The use of reticulated pore formers enables the manufacture of highly permeable ceramic filters with controlled pore size distribution.

as described in claim 1 or 2, the strong acid cation exchange agent class, the strong acid cation exchanger with a pore size distribution.

The results provide references in using bigger pore size geotextile to void clogging in filtration design.

The pore size and vacancy volume of the wire frame were determined under light microscope and SEM.

The pore size distributions (PSD) of samples were obtained by analyzing the isotherm with BJH equation.

The pore size and the pore size distribution of CA and PAN UF membrane were determined by liquid-liquid displacement method.

Secondly, the effect of pore size distribution on gas separation through carbon membrane is preliminary studied by slit-like pore model.

Mass transfer rate becomes fast as temperature rises or as pore size and porosity of membrane becomes large.

In this article, we focus on the air track gas source and the choice of pore size and the level of horizontal transfer method.

The influences of raw materials and phases on the porosity, gas per me ability, pore size and shape were studied.

The hard microporous material the gas flux distributing mensurate standard and method of different diameter pore size was introduced.

Pore size and porosity increased with the amount of the added PEG.

The average heat transfer coefficient is relatively sensitive to the pore size.

The carrier has the features of high titanium carrying amount, large pore size and containing no chlorine element.

The pore size is enlarged with the increasing of the temperature.

Increasing average pore size of coatings film has a trend of making ink clot more round.

Suction inking is available from the perspective of pore size into account.

The pore size distribution of the electrodes was analyzed using the BJH algorithm.

The winding patter is obtained by adjusting winding angle and pore size.

phenomenon by studying the effect of pore size distribution on the drying shrinkage.

they both had good pore size distribution and permeation.

Larger pore size is favorable to the ring opening reaction.

The pore size affect the protective coating ability.

The results are showed as follows: materials, pore size, the sample size on the compressive properties of aluminum foam have some effect.

Using new model of reserves calculation based on pore size to evaluate shale gas resources in Sichuan Basin.

What happens depends on pore size.

The carbon membranes prepared by smaller and more uniform particle size have a smaller pore size and abundant pore structure.

The more abrupt the change caused by capillary condensation is, the pore size distribution is more uniform.

Ammonium salt solution can catalyze the activation reaction and make the BET surface area and pore size increase.

Pore size-pore volume distributions of different activated carbons made in China and abroad were estimated by adsorption isotherm methods.

Measurement of the Specific Surface Area and Pore Size Distribution of the Sawdust Used in the Powdery Ammonium Nitrate Explosive

Fractal feature of pore size distribution of a marine soft soil and its application

Study of Factors Influencing Pore Size of Zirconia Ultrafiltration Membrane

Filter Element, Method of Determining the Pore Size of a Cleanable Surface Type Hydraulic Fluid Power

Preparation of Porous Carbon with Controlled Pore Size Distribution by Polymerization-dependent Phase Separation Technique

Study of structure characteristics evolution of soft clay by pore size distribution test

Comparison of Density Functional Theory and Molecular Simulation Methods for Pore Size Distribution of Mesoporous Materials

Preparation of Thermostable Silica-pillared Layered Niobic Acids with Different Interlayer Distance, Surface Area and Pore Size

Numerical simulation and characterization of materials'porosity, pore size, and surface roughness

Determination of Pore Size Distribution and Surface Area of Several Materials Using Mercury Porosimetry and Gas Adsorption

Effect of Particle Size and Membrane Pore Size on Crossflow Microfiltration of Micro-sized Particle Suspension Using Ceramic Membranes

Specific Surface Area and Pore-Size Distribution of the Bauxite Supporter and the Bauxite Supported Catalysts

Grand Canonical Ensemble Monte Carlo Simulation for Determination of Pore Size of Activated Carbon

Estimation of pore size distribution and permeability of shaly sands from induced polarization time spectra

Method for measurement of the equivalent pore size of fabrics (bubble pressure test)

Contrast of Nitrogen Adsorption Method and Mercury Porosimetry Method in Analysis of Shale's Pore Size Distribution

Calculation of Pore Size Distributions of Catalysts from Nitrogen Desorption Isotherms

Test Method for Pore Size Characteristics of Membrane Filters Using Automated Liquid Porosimeter

Study on the Pore Configuration (Pore Size Distribution) of Pyrolytic Chars from Waste Tires in Fluidized Bed Reactor

Study on preparation and energy storage of activated carbon electrode with special pore size distribution

fluoride; large pore size; ultrafiltration membrane. ;

Pore size and surface properties of activated carbon fibres modified by high temperature treatment

The Synthesis of Large Pore Size and Highly Ordered Silica Mesoporous Material with Cheap Domestic Reagent

The relationship of different pre-freezing temperature and the pore size of collagen sponge scaffold

permeable sintered metal materials . determination of bubble test pore size

pore size distribution of the samples moved to larger size in the carbonation process;

Control of Pore Size Distribution in Activated Carbon by Polymer Blend: Principles and Methods

Pore size distributions of samples oxidized at different temperatures

preparation of coal - based activated carbon with narrow pore size distribution

Standard Test Method for Pore Size Characteristics of Geotextiles by Capillary Flow Test

Advance in Pore Size Controlling Technology of Mesoporous Molecular Sieve

Measurement of pore size of geotextile under different pressures

Effect of pore size distribution on mass transfer in direct contact membrane distillation

The influence of parameters on the pore size of the alumina template

Effects of porosity and pore size on the electrical conductivity of open-cell aluminum foams

Effect of Anodic Oxidation by Oxalic Acid on Nanometer Pore Size of Aluminum Oxide Template

Influence of pore size distribution of concrete on the strength with grey system theory

Design and implementation of large pore size bored piles in Jinan Steel Factory

Quality control for construction of large pore size bored piles

test method for pore size distribution of refractory

Research on the Bubbling Pore Size of Woven Filter Cloth

Particle size and pore size distribution

Effect of pore size of D, L-polylactic acid as bone repair material on bone regeneration

Assuring the correct pore size filter

Effect of Cosurfactants on Pore Size of Mesoporous Silica

Use of Mercury Porosimetry to Characterize Pore Size and Porosity