pinion gear

At this point, the rollers move back into the shell, and the pinion gear turns faster than the armature shaft.

The starter motor is a simple direct current (DC) motor which has a pinion gear attached to its shaft.

The flywheel also has a large ring gear at its outer edge , which engages with a pinion gear on the starter motor during engine cranking .

The differential case supports the differential-pinion gear on a shaft, and this gear meshes with the two bevel gears.

Check that the pinion gear does not return inward after the cable of terminal C is disconnected.

A second cable assembly includes a second pinion gear mounted for rotational movement in the housing.

Spring-loaded rollers are wedged against the pinion gear inside the shell.

When the armature starts to spin, the rollers fit tightly between the shell and the pinion gear.

Rotate the pinion gear several complete revolutions to align the bearing rollers.

Most main gears are brass with a steel pinion gear.

The pinion gear now turns at the same speed as the armature shaft.

But once the engine starts, the ring gear begins to drives the pinion gear faster than the armature's rotation.

The shift lever moves the pinion gear away from the ring gear.

adapter or the pinion gear wrench assembly on the internal spline on the gearbox.

Inspect the clutch pinion gear return.

New "X" servo motor, new spindle bearings , new pinion &gear drive in 2007.

If the final drive ratio is 4. 10 times as many teeth as the input pinion gear.

a pinion gear positioning plate (20) is installed on the bending angle plate (19);