output terminals

An overvoltage and overcurrent protection for an exchange terminaL circuit has two input terminals and a number of output terminals.

The Route node has an unlimited number of dynamic output terminals through which flow processing activities may be executed.

The Service Invoke primitive has a single input terminal and a variable number of output terminals.

Not all dynamic output terminals that are created on a Route node need to be mapped to an expression in the filter table.

If an external load is connected across the output terminals of the PV cell, current will flow.

By adding the filter to the output terminals, the output voltage is controlled in an ideal interval.

Output terminals of a power supply (1) are communicated with two ends of the bar by wires respectively.

If you are using Java and require more than three output terminals. a full Java plug-in node would be required.

The Fan Out primitive has one input terminal and three output terminals, as shown in Figure 2.

Further output terminals are generated in the tooling for each fault message specified on the target service interface.

Dynamic terminals -- The Route node can have further dynamic output terminals.

The Fan In has two input and three output terminals, as shown in Table 2.

Then connect the voltmeter to the HI and LO output terminals of the switch card.

Dynamic terminals -- The DatabaseRoute node can have further dynamic output terminals.

In addition, the standard Compute node now provides 5 output terminals, allowing for much more flexible routing within a message flow.

Right-click RouteReply and select Add Output Terminal twice to create two more output terminals for the node.

Figure 7 shows a custom mediation containing two input terminals and three output terminals.

Note that the voltage at the source output terminals is 6V.

it makes the unnecessary input and output terminals "off" , such as monitor, keyboard and mouse etc.

In the switched-off condition or when the current supply is interrupted the three relay contacts on the output terminals 3 to 8 are open.

It can also internally decode DTS-HD Master Audio and output via HDMI or the 7. 1ch analog audio output terminals.

To do this you wire both of the non-failure output terminals to the same output location

Design of over-voltage filter at PWM inverter output terminals