mass flow-rate

The mass flow rate of the molten metal is controlled by means of a choke element fitted in the casting trough.

Experimental results manifest that this method is feasible and effective for mass flow rate measurement.

However, the rate of decrease in cooling water exit temperature decreases with an increase in air mass flow rate and spray water rate.

However, in this case it is easier to use a mass flow rate because referring to a hippo feed rate in terms of moles is impractical.

The results show that the system runs steadily when the driving flow mass flow rate equals to the diffuser outlet vapor flow mass flow rate.

Also, note that the mass flow rate value is recalculated from the velocity or volume flow rate value specified on an opening.

The relationship between the mass flow rate and RMS is established through the concentration of experiments.

Higher heat transfer rate as air mass flow rate increases. However, increase of heat transfer rate is less than that of air mass flow rate.

By the theory of fluid mechanism, atomization gas exit velocity and gas mass flow rate have been analysed.

Compared with the conventional axial compressor, the performance curves of the ram-rotor are vertical to the axis of mass flow rate.

The pressure so determined may then be used to correct mass flow rate computations or for other pressure measurement purposes per se.

A new program was developed to predict the pressure, temperature and mass flow rate of the flow in engine.

Oscillate phenomena of local wall temperature is found in the experiment, and is analyzed on the effect of heat flux and mass flow rate.

Results showed that the thrust increases appreciably at high mass flow rate together with high r.

The optimal coefficient of excess air was related to the mass flow rate of methane and wall temperature.

Instanced by the Coriolis mass flow rate meter, it is explained that how to apply this platform to developing control instruments.

The method of determining and regulating a mass flow rate exhaust gases recirculated into an engine is disclosed.

The effects of water content and chlorine mass flow rate on the selective monochlorination were investigated.

The influences of key design and operating parameters, such as bypass air ratio, compressor speed and total air mass flow rate etc.

Experimental study for the influences of mass flow rate of crystallizer on the gas hydrate cool storage process

results show both models described well the dependence of the mass flow rate of hydrophilic solids in the

Design and Numerical Investigation on a Small Mass Flow Rate Centrifugal Compressor

Test Method for Volumetric and Mass Flow, Rate Measurement in a Duct Using Tracer Gas Dilution

Theoretic analysis on the formula for granule mass flow rate of Coriolis mass flowmeter

Investigation on the Characteristic of the Mass Flow Rate in Adiabatic Capillary Tube

Testing Technology and Instruments on the Mass Flow Rate Measurement of Bulk Solids in Pneumatic Pipeline

Measurement of the velocity and mass flow rate in gas-solid flow with electrostatic method

Investigation of Oil-Air Two-Phase Mass Flow Rate Measurement Using Venturi and Void Fraction Sensor

Influence of air mass flow rate ratio on combustion efficiency of solid rocket ramjet with two air inlets

Research and development of electrostatic sensor on measurement of mass flow rate in coal particulate pipeline;

The Soft Sensor Model for Mass Flow Rate Measurement of Pneumatically Conveyed Solids Based on the Artificial Neural Network

A study of mass flow rate measurement based on the vortex shedding principle

Effects of nozzle contour in convergent section and throat on mass flow rate