mixing time

Concrete mixing time should be in line with "concrete structural engineering and construction inspection norms" .

The mixing time of molten steel in the ladle was measured with electrical conductivity method.

Equipped with a timer, the mixing time can be adjusted at option.

When the impeller was in the center of the tank, the mixing time was the shortest.

Under subsonic blowing condition, low lance position, high top and bottom blowing rate can decrease the mixing time.

The particle size and moisture content of the powder are affected by lime proportion and mixing time.

Mixing time decreased with the increase of impeller speed at the same volume concentration.

The draft tube with proper dimension and position could effectively decrease mixing time.

Must mix can be appropriately extended mixing time.

Powder mixed with use, Ying Shai except for coarse - grained and caking extended mixing time.

Mixing time is one of the key parameters to the design of stirred reactors.

The utility model has the advantages of gas-liquid contact, long mixing time, sufficient and even mixing, and good mixing effect.

The yellow index of blends at different mixing time and thermal aging time increased obviously than that of pure polymer.

The mixing time prolonged by introducing a draft tube.

This machine has many advantages, such as constant operation, low noise, high loading coefficient and short mixing time etc.

mixing time can be set within 30 minutes. this operation is very simple.

The results shows that the mixing time under subsonic blowing condition is remarkably longer than that under supersonic condition.

Mixing time was related to feeding position and the mixing time for charging in close to blade was shorter than that in liquid level.

Methods of test for petroleum and its products - Determination of fines mixing time of cationic bitumen emulsions

Balance Between Mixing Time-Delay and Amount of Mixer for Virtual Space Teleconferencing Systems

Study on effects of mixing time of wet-ground cement on mor tar properties

Water modeling of mixing time of CAS-OB bath with powder injection

Study on Hydraulic Modeling of the Airflow Rate and Uniform Mixing Time for ISA Smelting Process

Effects of different mixer and mixing time on uniformity degree of compound premix

A firm with control mixing time, when mixing time is unstable to all parts of the viscosity;

the outlet area ratio affects little shock pressure, liquid surface arrival time, mixing time and impact depth;

The difference of mixing time and contamination rate between liquid and powder preparations EN

Numerical simulation of mixing time in agitated tank with axial agitator blade

the outlet angle has a remarkable influence on shock depth, mixing time, and liquid surface arrival time;

Mixing time in stirred tank of three-phase gas-liquid-floating particle systems

Numerical Calculation of Mixing Time in Turbine Agitated Tank

Large Eddy Simulations of Mixing Time in a Stirred Tank

Influence of Mixing Time and Setting Time on Cement Paste Properties

A new method for determining mixing time in stirred tanks