lower limits

Physicists don't know how much the excited quark should weigh, if it exists, but they have set lower limits on its mass.

In a nutshell, facets further restrict a simple type by specifying the maximum length of a string or the upper and lower limits of a number.

Bandwidth: The difference (in hertz ) between the upper and lower limits of wave frequencies transmitted over a communications channel .

This paper DS18B20 done mainly through sensors to measure temperature, and through it to set the temperature of the upper and lower limits.

But most countries set lower limits, and China is expected to do so as well.

Confidence limits are the upper and lower limits of the confidence interval .

Note the second parameter of the EXTRACT that defines the upper and lower limits for the required index values.

The upper and lower limits of an airway shall be also defined.

Two switch measures ports (upper and lower limits), used in limited alarm or the ration controlling.

A method is presented to calculate approximate value of confidence lower limits making use of reliability test data of torpedo components.

Upper lower limits contacts (unless two upper or lower limits specificd) PD?

official upper and lower limits .

There are practical upper and lower limits of power for telescopes.

It is very important to choose proper solution of factor of safety when the upper limit and lower limits are certainly made.

However, there is debate about the optimal upper and lower limits of blood glucose.

the number of test cases that can be derived from a set of identified causes has upper and lower limits

Study on Processing Method of Data Near the Lower Limits of Detection for Radiation Environmental Monitoring

Determining the Porosity and Permeability Lower Limits of Reservoir Matrix by Productivity Simulation Technique

the designed point must be choosed at the lower limits of the ranges of working gas parameters (especially the pressure) or near to them;

The upper and lower limits of Normal tolerances for the bearing bore and outside diameter deviations;

To set the upper and lower limits of the working set, use

Method for determining the lower limits of effective reservoirs