Mark each cordset at the locations shown in Fig. 2. For samples employing molded cord guard assemblies, a cord clamp is usually not employed.
以下的图2表明了每个插头作标记的地方是要装配的地方。样品的成型尾档要安装，电线不需用夹具装配。
2
The cordset completed required cycles of flexing with no occurrence of end results and also successfully completed the Dielectric Strength Test without breakdown.
插头完成了要求的弯曲周期，没有出现上文所提到的最后结果，并且通过了电绝缘强度测试，没有损坏。
3
Flexing is then to be resumed for the remainder of the samples until end results occur again on a different cordset or until the required flex cycles are completed.