Many times (as with pinion gears) you will need to remove small setscrews (typically 3mm) that have been tightened as much as possible.
很多时候(与小齿轮)，你将需要删除的小定位螺丝(通常为3毫米)已拧紧尽可能。
2
At one end of the inner ring, the bearing is clamped to the shaft with an eccentric locking ring (Figure 1.7) or with two setscrews (Figure 1.8).
在内圈的一端，轴承通过偏心锁定环(图1.7)或者两个定位螺钉(图1.8)被固定在轴上。
3
Trying to remove these setscrews with a hex wrench (aka Allen wrench) that is the wrong size or even slightly worn will very likely strip the drive cup of the setscrew.