Increasing the water injection delay time and water injection pressure resulted in slightly decrease of the residual wall thicknesses of post-filled region.
提高注水压力与增加注水延迟时间时注水后填充部分的残留壁厚略有减小。
2
CAE for plastic injection molding software is usually divided into three subsystems: pre-processing system, numeric analysis system of injection molding process, and post-processing system.
塑料注射模cae软件一般划分为三个子系统：前置处理系统、注射成型过程数值分析系统和后置处理系统。
3
Objective: to observe the effects of new Qingkailing injection on the toxic substances accumulation post-hematencephalon.