If a saber saw is not available to you, a hand saw will work just as well for the straight-edged sawing and a keyhole saw will work for the curved edges.
For neater cuts, they can be cut by using a saber saw with a carbide blade or a masonry hole saw attachment for a drill.
Use a saber saw with a fine-tooth blade to cut the acrylic.
Most cuts can be made with a circular saw, handsaw, or saber saw, but the angled back support would be more easily cut with a table saw.
A sabre saw provides a fast, safe way to cut plywood paneling.
Cut along the inside pencil line with your sabre saw while another person supports it from below.
Make circular cuts and irregular angles with a keyhole or sabre saw.
Use a band or saber saw to cut the pattern from several boards at a time.
To compensate for the small curved corners use a saber saw to cut a small radius in the corner.
Use a small saber saw to cut a hole in the top of each pumpkin; clean them out, and save one of the pumpkin tops.
Table saw, saber saw, jigsaw (bevel cuts are required), or carpenter's handsaw and miter box are needed.
Your efforts to make the incident look work-related by falling onto a saber saw the next day is fairly ill-conceived and ends up eviscerating you in front of several dozen coworkers.
You can also use a saber saw with a carbide blade or, for small holes for plumbing pipes, you can use a tile cuffing attachment for your drill.
After 3 hours with a saber saw, the crazy pointy top is finished, and the crown of a kiosk is assembled.
All of the cuts can be made with a table saw and a band saw or sabre saw, and a large drill bit.
Drill a starter hole for your sabre saw, then cut around the outline and remove the cutout.
The laminate should be cut with a sabre saw fitted with a fine-toothed blade, and cuts should be made leaving a half-inch margin on all sides but the factory edge.
Most of the project requires basic wood-working tools - a circular saw, a saber saw, an electric drill, a hammer, and a nail set.
If you haven't had your shelving sides cut at the lumberyard, the next step is to use the saber saw to cut the 2 side pieces for the shelving unit as well as the 2 shelves for over the closet rods.
The polystyrene foam is often cut into shapes with chain saws and saber saws.